ZyXEL Communications P314 2.2Prestige 314 Rear Panel and Connections, Step 1: Connecting the Console Port, Figure 2-2Prestige Rear Panel and Connections

P314 Broadband Sharing Gateway with 4-Port Switch

LEDs	Function	Indicator	Active	Description
		Status
			On	The WAN Link is ok.
			Flashing	The 10M WAN link is sending/receiving packets.

2.2Prestige 314 Rear Panel and Connections

The following figure shows the rear panel of your Prestige 314 and the connection diagram.

Figure 2-2 Prestige Rear Panel and Connections

This section outlines how to connect your Prestige 314 to the LAN and the WAN. In the case of connecting a cable modem you must connect the coaxial cable from your cable service to the threaded coaxial cable connector on the back of the cable modem. Connect a DSL Modem to the DSL Wall Jack. Please also see the Appendices for important safety instructions on making connections to the Prestige.

Step 1: Connecting the Console Port

For the initial configuration of your Prestige, you need to use terminal emulator software on a workstation and connect it to the Prestige through the console port. Connect the 9-pin end of the console cable to the console port of the Prestige and the other end (choice of 9-pin or 25-pin, depending on your computer) end to a serial port (COM1, COM2 or other COM port) of your workstation. You can use an extension RS-232

2-2 Hardware Installation and Setup