P314 Broadband Sharing Gateway with 4-Port Switch

Menu 24.7.2 - System Maintenance - Upload Router Configuration File

To upload the router configuration file, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your router. Then type "root" and SMT password as requested.

3.Type "put configurationfilename rom-0" where "configurationfilename" is the name of your router configuration file on your workstation, which will be transferred to the "rom-0" file on the router.

4.The system reboots automatically after the upload router configuration file process is complete.

For details on FTP commands, please consult the documentation of your FTP client program. For details on uploading router firmware using TFTP (note that you must remain on this menu to upload router firmware using TFTP), please see your router manual.

Press ENTER to Exit:

Figure 9-9 Telnet into Menu 24.7.2 – System Maintenance

To transfer the firmware and the configuration file, follow these examples:

9.6.1 Using the FTP Command from the DOS Prompt

Step 1. Launch the FTP client on your workstation. Step 2. Type open and the IP address of your Prestige.

Step 3. You may press [ENTER] when prompted for a username.

Step 4. Type root and your SMT password as requested. The default is 1234. Step 5. Type bin to set transfer mode to binary.

Step 6. Use “put” to transfer files from the workstation to the Prestige, e.g., put p314.bin ras transfers the firmware on your computer (p314.bin) to the Prestige and renames it “ras”. Similarly put p314.rom rom-0transfers the configuration file on your computer (p314.rom) to the Prestige and renames it “rom-0”. See section 9.1 for more information on filename conventions.

Step 7. Type quit to exit the ftp prompt.

Transferring Files

9-9