
P314 Broadband Sharing Gateway with
2.4Power Up Your Prestige
At this point, you should have connected the console port, the LAN port, the WAN port and the power port to the appropriate devices or lines. Plug the power adapter into a wall outlet. The Power LED should be on. The SYS LED will come on after the system tests are complete. The WAN LED and one of the LAN LEDs come on immediately after the SYS LED comes on, if connections have been made to the LAN and WAN ports.
Initial ScreenWhen you power on your Prestige, it performs several internal tests as well as line initialization. After the tests, the Prestige asks you to press [Enter] to continue, as shown.
Copyright (c) 1994 - 2000 ZyXEL Communications Corp. initialize ch =0, ethernet address: 00:a0:c5:41:51:61 initialize ch =1, ethernet address: 00:a0:c5:41:51:62 Press ENTER to continue...
Figure | Initial Screen |
The login screen appears after you press [Enter], prompting you to enter the password, as shown below. For your first login, enter the default password 1234. As you type the password, the screen displays an (X) for each character you type.
Please note that if there is no activity for longer than 5 minutes after you log in, your Prestige will automatically log you out and will display a blank screen. If you see a blank screen, press [Enter] to bring up the login screen again.
Enter Password : XXXX
Figure2.5Navigating the SMT Interface
The SMT (System Management Terminal) is the interface that you use to configure your Prestige.
Several operations that you should be familiar with before you attempt to modify the configuration are listed in the table below.
Hardware Installation and Setup |