P314 Broadband Sharing Gateway with
on LAN to use the MAC Address of that workstation whose IP you give in the following field.
IP Address This field is applicable only if you choose IP Address attached on LAN method. Enter the IP address of the workstation on the LAN whose MAC you are cloning.
2.9LAN Setup
This section describes how to configure the LAN using Menu 3 – LAN Setup (10/100 Mbps Ethernet). From the Main Menu, enter 3 to open Menu 3.
Menu 3 - LAN Setup
1.LAN Port Filter Setup
2.TCP/IP and DHCP Setup
Enter Menu Selection Number:
Figure 2-10 Menu 3 – LAN Setup
2.9.1 LAN Port Filter Setup
This menu allows you to specify the filter sets that you wish to apply to the LAN traffic. You seldom need to filter the LAN traffic, however, the filter sets may be useful to block certain packets, reduce traffic and prevent security breaches.
Menu 3.1 – LAN Port Filter Setup
Input Filter Sets: protocol filters= 2 device filters=
Output Filter Sets: protocol filters= device filters=
Press ENTER to Confirm or ESC to Cancel:
Figure 2-11 Menu 3.1 – LAN Port Filter Setup
Menu 3.2 is discussed in the next chapter.
Hardware Installation and Setup |