P314 Broadband Sharing Gateway with 4-Port Switch

 

Table 10-2

Call History Fields

Field

 

Description

 

 

Phone Number

The PPPoE service names are shown here.

 

 

Dir

This shows whether the call was incoming or outgoing.

 

 

Rate

This is the transfer rate of the call.

 

 

#call

This is the number of calls made to or received from that telephone

 

number.

 

 

 

Max

This is the length of time of the longest telephone call.

 

 

Min

This is the length of time of the shortest telephone call.

 

 

Total

This is the total length of time of all the telephone calls to/from that

 

telephone number.

 

 

 

 

10.3 Boot Commands

When you reboot your Prestige, you will be given a choice to go into debug mode by pressing a key at the prompt shown in the following screen. In debug mode you have access to a series of boot module commands, for example ATUR (for uploading firmware) and ATLC (for uploading the configuration file) already discussed in Chapter 9.

Bootbase Version: V1.05 4/14/2000 13:58:03

RAM: Size = 4096 Kbytes

FLASH: Intel 8M

ZyNOS Version: V3.20(CA.0)b3 6/12/2000 18:00:34

Press any key to enter debug mode within 3 seconds.

.................................................

Figure 10-6 Option to Enter Debug Mode

Enter ATHE to view all available Prestige boot module commands as shown in the next screen. ATBAx allows you to change the console port speed. The x denotes the number preceding the colon to give the console port speed following the colon in the list of numbers that follows; e.g., ATBA3 will give a console port speed of 9.6 Kbps. ATSE displays the seed that is used to generate a password to turn on the debug flag in the firmware. The ATSH command shows product related information such as boot module version, vendor name, product model, RAS code revision, etc. ATGO allows you to continue booting the system. Most other commands aid in advanced troubleshooting and should only be used by qualified engineers.

10-4

System Maintenance and Information