Ryobi RY64400 Troubleshooting, Preparing for USE After Storage, High Altitude Engine Operation

Page 17

MAINTENANCE

While holding a wrench on the flats of the adjusting nut with one hand, loosen the retaining nut with a second wrench as shown. Take care not to loosen the stud.

Rotate the adjusting nut until it touches the feeler gauge. Once the gap setting is correct, hold the wrench on the flats of the adjusting nut and re- tighten the retaining nut securely.

Adjust the second rocker arm, if necessary.

Replace the rocker arm cover and screw; tighten securely.

Replace the top engine cover and screw; tighten securely.

WARNING:

Ensure all engine cover and all engine parts are com- pletely and properly reassembled before starting engine. Failure to correctly reassemble engine may result in seri- ous injury or property damage.

PREPARING FOR USE AFTER STORAGE

The following steps should be taken before using the cultiva- tor after it has been stored.

nUnfold the handles into the upright position and secure by tightening handlebar knobs. Do not allow throttle cable to become pinched when raising the handlebar.

nPull the starter cord three or four times to clean lubricant from the combustion chamber.

nRemove spark plug from the cylinder. Wipe lubricant from the spark plug and return it to the cylinder.

nReconnect spark plug wire.

nFollow the steps on pages 8-9 to refuel and restart the cultivator.

HIGH ALTITUDE ENGINE OPERATION

Please have an authorized service center adjust this engine if it is to be run above 2000 feet. Failure to do so may result in poor engine performance, spark plug fouling, hard start- ing, and increased emissions. Carburetor adjustment by an authorized service center will improve performance and allow that this engine meets EPA (Environmental Protection Agency) and California ARB (Air Resources Board) emis- sion standards. An engine adjusted for high altitudes can not be run at 2000 feet or lower. In doing so, the engine will overheat and cause serious engine damage. Please have an authorized service center restore high altitude modified engines to the original factory specification before operating below 2000 feet.

TROUBLESHOOTING

PROBLEM

 

CAUSE

REMEDY

Engine fails to start.

On/stop switch is in the off position.

Move switch to on.

 

No fuel in tank.

Fill tank.

 

Spark plug shorted or fouled.

Replace spark plug.

 

Spark plug is broken (cracked

Replace spark plug.

 

porcelain­

or electrodes broken).

 

 

Ignition lead wire shorted, broken, or

Replace lead wire or attach to spark

 

disconnected from spark plug.

plug.

 

Ignition inoperative.

Contact authorized service center.

 

 

 

Engine hard to start.

Water in gasoline or stale fuel mixture.

Drain entire system and refill with fresh

 

 

 

fuel.

 

Obstructed fuel filter

Replace filter.

 

Engine is under or over choked.

Adjust choke as necessary.

 

Weak spark at spark plug.

Contact authorized service center.

Engine lacks power.

Air filter clogged.

Clean or replace air filter.

 

 

 

Engine emits too much smoke

Too much oil in crankcase.

Drain lubricant and refill with correct

 

 

 

amount of 20W-30 engine lubricant. See

 

 

 

Adding/Checking Engine Lubricant

 

 

 

in the Operation section of this manual.

 

 

 

 

13 - English

Image 17
Contents Save this Manual for Future Reference OPERATOR’S ManualDEJ Iii AE B Screw vis, tornillo E Gasket joint, junta Introduction Table of ContentsGeneral Safety Rules Refueling Specific Safety RulesService Symbol Name Explanation SymbolsSymbol Signal Meaning Assembly FeaturesInstalling the Handlebar Installing the Front HandleInstalling the WHEEL/DRAG BAR Assembly OperationOxygenated Fuels Fueling and Refueling the CultivatorApplications STARTING/STOPPING the CultivatorPreparing a Seed BED If Assistance is Required for this ProductGeneral Cultivating See FiguresUsing the Cultivator for Edging AdjustmentsAdjusting WHEEL/DRAG BAR Assembly Position Edging TipsMaintenance Changing Engine Lubricant Adjusting CAMSHAFT-TO-ROCKER ARM ClearanceStoring the Cultivator See Figures 21Problem Cause Remedy TroubleshootingPreparing for USE After Storage High Altitude Engine OperationIgnition Assy WarrantyLimited Warranty Statement MANUFACTURER’S Warranty Coverage English AVERTISSEMENT  Règles DE Sécurité GénéralesConserver CES Instructions DépannageRavitaillement EN Carburant Règles DE Sécurité ParticulièresAura pour conséquences des blessures graves ou mortelles SymbolesSymbole Signal Signification Assemblage CaractéristiquesInstallation DE Poignée DU Guidon Installation DE LA Poignée AvantInstallation DE L’ENSEMBLE ROUES/ Guide DE Profondeur UtilisationCarburants Oxygénés Approvisionnement EN CarburantApplication Mise EN Marche ET Arrêt DU CultivateurEN CAS DE Besoin D’ASSISTANCE Démarrage Avec CE Produit Installer LES Bordures À DentsPréparation DU LIT DE Semis Travail Général DU SOLRéglages Pour réinstaller les lames dentées du cultivateurProfondeur Avis Réglage DE L’ENSEMBLE ROUES/GUIDEEntretien Remplacement DE LA BougieEntretien Général Nettoyage DU Filtre À AIRChanger LE Lubrifiant À Moteur PARE-ÉTINCELLESNettoyage DE L’ORIFICE D’ÉCHAPPEMENT ET DU Silencieux Remisage DU CultivateurDépannage Problème Cause SolutionRéglage DU Ralenti Préparation À L’EMPLOI Après LE RemisageLa figure GarantieÉnoncé DE LA Garantie Limitée Responsabilités DU Propriétaire Dans LE Cadre DE LA Garantie Français ¡ADVERTENCIA Reglas DE Seguridad GeneralesGuarde Estas Instrucciones ServicioReabastecimiento DE Combustible Reglas DE Seguridad EspecíficasPeligro SímbolosAdvertencia PrecauciónArmado CaracterísticasInstalación DEL Mango Delantero FuncionamientoInstalación DE LA Barra DEL Mango Instalación DEL Conjunto DE LAS RuedasCombustibles Oxigenados Abastecimiento Y Verificación DE LubricanteUsos Encendido Y Apagado DE LA CultivadoraCultivo General SI Necesita Asistencia Para EL ­ARRANQUE Este ProductoLA Preparación DE LA Cama DE Semillas Profundidad Consejos AjustesUSO DE LA Cultivadora Para Recortar Bordes Mantenimiento Cómo Guardar DE LA Cultivadora Limpieza DEL Orificio DE Escape Y DEL SilenciadorAjuste DE LA Apertura DEL Árbol DE Levas DEL Balancín Vea las figuras 20 aProblema Causa Solución Solución DE ProblemasAjuste DE LA Marcha Lenta Operación DEL Motor a Altitudes Elevadas¿NEC GarantíaDeclaración DE LA Garantía Limitada Cobertura DE LA Garantía DEL Fabricante Notas California Proposition Manuel D’UTILISATION Manual DEL OperadorProposition 65 DE L’ÉTAT DE Californie California Propuesta DE LEY NÚM

RY64400 specifications

The Ryobi RY64400 is a powerful and efficient tool designed for homeowners and DIY enthusiasts alike, primarily focusing on enhancing outdoor lawn care and maintenance. This electric lawn mower combines innovative technology with a user-friendly design, ensuring that users can achieve a pristine lawn without the hassle typically associated with traditional mowers.

One of the most notable features of the RY64400 is its 40V battery-powered system. This eco-friendly power source provides users with the freedom to operate without the constraints of gas or cords, making it ideal for maintaining lawns of various sizes. The 40V lithium-ion battery delivers ample runtime, enabling users to mow for extended periods on a single charge. Additionally, the RY64400 features a convenient battery indicator, allowing users to monitor battery life and plan their mowing sessions effectively.

Another significant characteristic of this mower is its 21-inch cutting deck. This width is perfectly balanced for maneuverability and efficiency, allowing users to cover more ground in less time while still being able to navigate tight spaces and obstacles seamlessly. Moreover, the cutting height is adjustable with five different settings that range from 1.5 inches to 4 inches, ensuring users can achieve their desired grass length for optimal lawn health.

The RY64400 incorporates advanced brushless motor technology, which enhances the mower's overall performance and runtime. This technology reduces maintenance needs while also improving power efficiency, resulting in less noise and lower vibrations for a more comfortable mowing experience.

Additionally, the mower features a 3-in-1 design that allows for mulching, bagging, and side discharge of grass clippings. This versatility not only accommodates various yard care preferences but also promotes healthy lawn growth by returning nutrients back to the soil when mulching.

User convenience is further prioritized with features such as a foldable handle for easy storage and transportation, as well as a lightweight design that makes it easy to maneuver. The RY64400 also includes a push-button start for quick and hassle-free operation, eliminating the problems often associated with traditional pull-start engines.

In conclusion, the Ryobi RY64400 marries power, efficiency, and convenience, making it a standout choice for those seeking a reliable electric lawn mower. With its eco-friendly battery system, innovative technology, and versatile features, maintaining a beautiful lawn has never been easier. Whether one is a seasoned gardener or just starting out, the RY64400 is designed to meet various lawn care needs with ease.