English
6. Set up
SE1 |
■MOUNTING ENGINE (SE1)
1.Push the drive shaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.
2.Insert the drive shaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.
3.Fasten the clamp securely with two screws.
SE2
SE3
SE4
(1)
SE5
SE6(1)
IMPORTANT
Tighten the screws gradually by turns.
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)
■CONNECTING SWITCH WIRES (SE3)
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.
•Bind switch wires to throttle wire with tie band.
(1) Tie band
■INSTALLING HANDLE
(BC-EX2, LRT-EX only) (SE4)
•Install the handle to the shaft tube and clamp it at a location that is comfortable to you.
(1) About 19 inches (48 cm)
(RMS-EX only) (SE5)
1.Remove both screws from the handle.
2.While spreading the handle at the mounting hole, position the handle on the outer tube as shown.
3.Reinstall the two mounting screws in the handle, but do not tighten them at this time.
NOTE
One side of the handle is recessed to receive the hex nuts.
4.Locate the handle at the best position for operator comfort (usually about 10inches (25cm) ahead of the throttle lever), and secure it by tightening the knob at the handle base.
■JOINT ATTACHMENT (SE6)
•Insert the attachment to the main shaft.
•Tighten the knob bolt securely.
(1) Knob bolt
20