2 Getting Started
A. Design & Installation Considerations |
| C. Inspect Appliance & Components |
|
| |
| WARNING | |
operate with all combustion air siphoned from outside of the |
| |
building and all exhaust gases expelled to the outside. No |
|
|
| Inspect appliance and components for | |
additional air source is required. |
| |
| damage. Damaged parts may impair safe | |
|
| |
|
| operation. |
CAUTION |
| • Do NOT install damaged components. |
| • Do NOT install incomplete components. | |
Check building codes prior to installation. |
| • Do NOT install substitute components. |
|
| |
• Installation MUST comply with local, regional, state |
| Report damaged parts to dealer. |
and national codes and regulations. |
|
|
|
|
•Consult local building, fire officials or authorities having
jurisdiction about restrictions, installation inspection, • Carefully remove the appliance and components from
| and permits. |
| the packaging. | |
|
| • Remove cast door and glass door, and set aside on pro- | ||
When planning an installation, it is necessary to determine | ||||
| tective surface. | |||
the following information before installing: | • | Remove log set and component pack from firebox. | ||
• | Where the appliance is to be installed. | |||
• | Report to your dealer any parts damaged in shipment, | |||
• The vent system configuration to be used. |
| particularly the condition of the glass. | ||
• | Gas supply piping. | • | Read all of the instructions before starting the instal- | |
• | Electrical wiring. |
| lation. Follow these instructions carefully during the | |
| installation to ensure maximum safety and benefit. | |||
|
|
| ||
•Whether optional accessories - devices such as a blower, thermostat or remote control - are desired.
|
|
|
|
| WARNING |
|
|
| WARNING |
|
| Hearth & Home Technologies disclaims any | |||
|
|
|
|
| responsibility for, and the warranty will be | ||
|
|
|
|
| |||
| Keep appliance dry. |
|
| voided by, the following actions: | |||
| • Mold or rust may cause odors. |
| • Installation and use of any damaged appliance or vent | ||||
| • Water may damage controls. |
|
| ||||
|
|
| system component. |
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
| • Modification of the appliance or vent system. | ||
|
|
|
|
| |||
|
|
|
|
| • Installation other than as instructed by Hearth & Home | ||
B. Tools and Supplies Needed |
|
| Technologies. |
|
| ||
|
| • Improper positioning of the gas logs or the glass door. | |||||
Before beginning the installation be sure that the following | • Installation and/or use of any component part not approved | ||||||
tools and building supplies are available. | Note: Not all | by Hearth & Home Technologies. |
|
| |||
tools will apply to every installation. |
|
| Any such action may cause a fire hazard. | ||||
| Reciprocating saw | Variable Speed Drill/Driver |
|
|
| ||
|
|
|
| ||||
| Pliers |
|
|
| |||
| Wrench Set |
|
|
|
|
| |
| Hammer |
|
|
|
|
| |
| Framing Square |
|
|
|
|
| |
| Phillips Screwdriver |
|
|
|
|
| |
| Framing Material |
|
|
|
|
| |
| Flat Blade Screwdriver |
|
|
|
|
| |
| Hi temp caulking material |
|
|
| |||
| Plumb Line | Voltmeter |
|
|
|
|
|
| Level |
|
|
|
|
| |
| Gloves |
|
|
|
|
| |
| Manometer |
|
|
|
|
| |
| Safety Glasses |
|
|
|
|
| |
| Tape Measure |
|
|
|
|
| |
|
|
|
| ||||
|
|
|
|
| |||
|
| or combustible gas detector |
|
|
| ||
|
|
|
|
|
|
| |
Page 6 |
| January 28, 2008 | |||||