Snapper 7800580, 7800696 manual Check Safety Interlock System, Clean Debris Off Mower, Washout Port

Page 17

 

Maintenance

Check Safety Interlock System

11. Start the engine and run for 2-3 minutes, to allow the

1. Start the mower.

underside of the mower deck to dry.

 

2.Release the blade control. The engine must stop within 3 seconds.

If the engine does not stop, do not use the mower. Bring the mower to an authorized dealer for service.

Clean Debris Off Mower

A

!

WARNING

!

DO NOT attempt any maintenance, adjustments or service

 

 

with engine and blade running. STOP engine and blade.

 

 

Remove starter insert. Disconnect spark plug wire and

 

 

 

Figure 15: Washout port

secure away from spark plug. Engine and components are

 

HOT. Avoid serious burns, allow sufficient time for all com-

 

 

ponents to cool. Wear heavy leather gloves when handling

 

 

or working around cutting blades. Blades are extremely

 

 

sharp and can cause severe injury.

 

 

 

 

 

 

 

 

Reproduction

1. Clean dirt and debris from the top of the mower deck.

 

 

2. Clean any debris buildup on or around the engine, etc.

 

 

While cleaning, check components for wear or damage.

 

 

Replace worn or damaged components immediately.

 

 

Washout Port

!

WARNING

!

• Use appropriate eye protection.

 

• Keep people and pets out of the area.

 

• Stay behind the handle while the engine is running.

• Do not attempt mowing operations while using the

washout port.

 

 

• Do not attempt to look under or reach und

the mower

deck for any reason while using the washout port. Serious injury can result.

The washout port allows hands-free cleaning of the underside of the mower deck. To use the washout port:

1.Be sure the grass bag and side discharge deflector are removed.

2.Set the height of cut to the lowest position.

3.Move the mower to a level, paved surface.

4.Stop the engine.

5.Connect the male end of a standard garden hose to the washout port connector (A, Figure 15).

6.Turn on the water supply to the garden hose.

7.Start the engine and run until no more debris emerges from under the mower deck.

8.Stop the engine.

9.Turn off the water supply to the garden hose.

10.Disconnect the garden hose from the washout port connector.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Manual No Rev. B NotEngine Date of Purchase RetailerEquipment Reproduction For From Previous Column Operator SafetyDo not put hands or feet near or under rotating parts From Previous From Previous ColumnSecurely Do not store mower or fuel container inside where Serious bodily injury or death Operator Safety Safety and Operation DecalsExplanation of Operation Decals Contact your dealer if you have questions Features and ControlsBefore Starting Void he engine warrantyFuel Recommendations Fuel must meet these requirementsOperation Starting the Mower Handle Height AdjustmentPropelling the Mower Stopping the MowerMulching Operation Operation Cutting Height AdjustmentRe 10 Installing the grass bag Operation Installing the Grass BagOperation Charging the Battery Operation Maintenance Reminder Emissions Control Maintenance Maintenance ChartRecommended. Do not overfill Maintenance Change Engine Oil Service Air FilterClean Debris Off Mower Check Safety Interlock SystemWashout Port Turn on the water supply to the garden hoseFuel System Maintenance Drive Control Adjustment Storage ProcedureLoose dipstick Fuel tank empty Fill fuel tank with fresh fuelBuild-up of debris on or around drive Determine warranty eligibility BatteryWarranties ReproductionYour Warranty Rights And Obligations Not For Slope Guide Engine SpecificationsMower Eproduct ion For Motor EquipoSeguridad del usuario Solución de problemas GarantíasCaracterísticas y mandos Operación MantenimientoContinuación de la columna previa Seguridad del usuarioReduzca la velocidad antes de realizar giros Materiales puede rebotar hacia el usuarioLa esté cruzando Camiones cerradosProducirse lesiones físicas graves o la muerte Seguridad del usuario Etiquetas transparentes deSeguridad y funcionamiento Explicación del significado de las etiquetas Funcionamiento ReproductionPreguntas que formular Características y mandosOfrecen únicamente como referencias y pueden diferir de Su concreto modelo. Contacte con su distribuidor si tieneRecomendaciones sobre combustible Antes de empezarAjuste de altura del mango Operación Encendido del cortacéspedPropulsión del cortacésped Detención del cortacéspedFuncionamiento de la desmenuzadora Operación Ajuste de altura de corteLos componentes se enfríen Tire de la palanca de ajuste de la altura de corte aLas bolsas del receptor de césped están fabricadas con tela Operación Instalación de la bolsa de céspedTejida y están sometidas al deterioro y el desgaste durante Su uso normal. Revise el estado de la bolsa antes de usarlaÁrea donde se realiza la carga de la batería. Nunca use Operación Carga de la bateríaCargadores Aumentadores con la batería Mantenga cualquier chispa, llama o fuego al jadosHoras totales BujíaHoras de desactivación Filtro de aireControl de emisiones Mantenimiento Tabla de mantenimientoCada 8 horas o diariamente Primeras 5 horas Cada 50 horas o anualmenteFiltro de aire Cortacésped Limpieza de los desechos delPuerto de deslave En 3 segundosSistema de combustible MantenimientoSolución de problemas Reproduction Equipo GarantíasMotor BateríaAbril Notas Inclinación Guía DE InclinacionesEspecificaciones Not Eproduct ion Moteur Date d’achat DistributeurÉquipement Manipulation Équipé d’un pare-étincelles, tel que défini dansSuite de la colonne précédente Sécurité de l’opérateurEst en marche FonctionnementLa mort Sécurité de l’opérateur Autocollants de fonctionnement etDe sécurité ’éviter de les blesser Place Tondre les pentes de biais, ne pas les monter ni lesMoins deux 2 minutes avant de faire le plein ’essence Sac à herbe doCaractéristiques et commandes Avant de démarrer Recommandations de carburantArrêt de la tondeuse Fonctionnement Démarrage de la tondeusePropulsion de la tondeuse Fonctionnement Réglage de la hauteur de coupe Dépose du bouchon de déchiquetage Fonctionnement Installation du sac à herbePoint d’accès de recharge de la batterie Fonctionnement Recharge de la batterieTotal des heures Fonctionnement Aide-mémoire d’entretienHeures de parcours Filtre à air HorlogeSystème de contrôle des émissions Entretien Tableau d’entretienEntretien du filtre à air EntretienPoint d’accès de rinçage Entretien Contrôler le système de verrouillage de sécuritéNettoyage de la tondeuse Système d’alimentation Entretien Réglage de la commande’entraînement Dépannage La machine a été modifiée d’une GarantiesÉquipement MoteurAvril Reproduction Pentes Sur les Guide DE PenteSpécifications

NXT22875EFCA, NXT22875E, 7800580, 7800696 specifications

The Snapper 7800580, 7800696, NXT22875EFCA, and NXT22875E are part of a cutting-edge line of outdoor power equipment designed for efficiency and user-friendliness. Tailored for both residential and commercial applications, these models showcase advanced engineering, robust features, and superior technology that cater to a variety of landscaping needs.

The Snapper 7800580 and 7800696 models feature powerful engines that deliver high torque and performance, ensuring that even the toughest mowing tasks are accomplished with ease. They include a self-propelled functionality that enhances maneuverability across various terrains, making them ideal for uneven lawns or large yards. The adjustable cutting height feature provides users with the ability to customize the grass length, leading to a perfect finish every time.

Both models incorporate Snapper’s signature cutting deck design, which optimizes airflow for better mulching, clipping discharge, and bagging. This innovative deck technology also reduces the risk of clogging, allowing for a smoother mowing experience. Additionally, these mowers are equipped with easy-start systems, enabling quick ignition without the hassle of priming.

Transitioning to the NXT22875EFCA and NXT22875E, these models are noted for their brushless motor technology, which provides increased efficiency and longevity compared to traditional motors. The brushless design reduces maintenance needs and extends the overall lifespan of the equipment. With an emphasis on battery-powered operation, both NXT22875 models are designed for low emissions, making them environmentally responsible choices for landscaping enthusiasts.

The NXT22875 series also boasts user-friendly features such as adjustable speed settings, allowing operators to tailor their mowing pace according to the terrain and grass conditions. Further enhancing the user experience, these mowers have ergonomic handles that reduce fatigue during extended use.

Safety is a key consideration in the design of all_four models, with features such as blade brake systems and durable construction that improves stability and reduces the risk of accidents. The combination of technological advancements, user-centric design, and powerful performance makes the Snapper 7800580, 7800696, NXT22875EFCA, and NXT22875E exceptional choices in the realm of outdoor power tools. Whether for professional landscaping or home lawn care, these models deliver quality, reliability, and versatility, meeting the diverse needs of users.
Top Page Image Contents