Murray 1737921 Slow Engine Run Fast, Engine Stop, Traction Control, Engage Down, Auger Clutch

OPERATOR SAFETY

Control Symbols on Equipment

Oil
Fuel		Forward
On Off		Neutral
Choke Off		Reverse
Choke On
		Electric Start -
Stop		Engage (Down) &
		Disengage (Up)
Slow		Engine - Run
Fast	STOP	Engine - Stop

Traction Control -	Auger Control -
Engage (Down)	Engage (Down)

Auger Clutch	Chute Deflector
	(Up and Down)

Discharge Chute	Heated Hand Grips
(Left and Right)	(High and Low)

	1	2
Easy-TurnTMTraction Control	Free-HandTMControl

Read the Manual

DANGER

Read, understand, and follow all the instructions on the snow thrower and in the operator’s manual before operating this unit.

Failure to observe the safety instructions in this manual will result in death or serious injury.

•Be thoroughly familiar with the controls and the proper use of the snow thrower.

•Make sure you are properly trained before operating the snow thrower.

•Know how to stop the unit and disengage the controls quickly.

•Never allow anyone to operate the snow thrower without proper instruction.

•Always follow the instructions in the operator’s manual, if the snow thrower will be stored for an extended period.

•Maintain or replace safety and instruction labels as necessary.

•Never attempt to make major repairs on the snow thrower unless you have been properly trained. Improper servicing of the snow thrower can result in hazardous operation, equipment damage, and voiding of the product warranty.

Discharge Chute

DANGER

Discharge chute contains rotating impeller to throw snow. Never clear or unclog the discharge chute with your hands. Fingers can quickly become caught in the impeller. Always use a clean-out tool.

Failure to observe these safety instructions will result in traumatic amputation or severe laceration.

TO SAFELY CLEAR A CLOGGED DISCHARGE CHUTE

DANGER: Hand contact with the rotating impeller inside the discharge chute is the most common cause of injury associated with snow throwers. Never use your hands to clean out the discharge chute.

FOLLOW THESE INSTRUCTIONS:

1.Shut OFF the engine.

2.Wait 10 seconds to be sure the impeller blades have stopped rotating.

3.Always use a clean-out tool, not your hands.

NOTE: Not all control symbols shown on this page will appear on your snow thrower. See FEATURES AND CONTROLS section for the applicable symbols.

5