Kodak Printe manual To remove the SIMMs, To install the new Simm

Page 32

VinylJet 36TM Reference Guide

➪To remove the SIMMs

1Facing the top of the SIMMs, push the side clips gently to the outside (away from the SIMM).

2Push over and pull out, being careful not to damage the fingers on the top.

➪To install the new SIMM

1Insert at a 45 degree angle and slowly push the SIMM to a 90o angle until the two side clips snap into place. Make sure the SIMM is fully seated.

2Carefully reconnect the ribbon cable harness to the connector on the PC board. Reattach the other connectors removed earlier.

3Reinstall the right cover and top cover.

Installing additional memory A-2

Image 32

Contents Text P/N Revision HistoryWarranty Claims FCC Statement U.S.A VDE statementIndustry Canada Material safety data sheetGeneral operating safety For your safety Manual conventions Other reference materialsContents Appendix a Installing additional memory Appendix C Technical information Appendix D Error messagesAppendix E Troubleshooting Appendix B Menu treePrinter setup Use the right inks and media PrintingObtaining quality results Caring for your media Caring for your ink and cartridgesChoose the right media Choose the correct printing mode Use the right softwareReturning to the default settings Printing the settingsPrinter options Important notes about image size vs. dpiChoosing quality mode options Color modeTo choose the color mode To choose print quality Choosing feed media optionsMedia counter To enter a media length valueTo reset the media counter Auto-load delayTo set auto-load delay To display the current valueDefining user setup Save mediaTo turn off Save Media Auto-WipeTo save user setup To use a previously saved user settingChoosing a language To choose a languageTo set ink reduction To set LCD contrastChoosing ink options To set the ink preheat time To set dry EOPPrinter default settings User Settings Default Other OptionsTo print a file using the Windows driver PrintingEnd of Print function Printing modes Printing vector dataAccessing HP-GL/2 features To access HP-GL/2 featuresPalette select To choose a palette typeTo set control ControlRotation To make multiple prints ReprintsTo rotate the image Nesting To define nesting wait time To enable nestingNest time To enable the ink limit Ink limitInstalling additional memory Simm installationAcceptable Simm sizes To remove the right coverTo install the new Simm To remove the SIMMsMenu tree Main menu at a glanceMain menu Feed media menuSetup menu at a glance Bold indicates the default Utility menu at a glance Bold indicates the default Setup menu Print ModeHP-GL/2 Menu Ink Option Menu Serial Comm Menu Bold indicates the default Utility menuPrime menu Service Menu Bold indicates the default Technical information Media Roll ParametersTechnical information C-2 Error messages Cartridge errorsMemory Errors Isolating problems TroubleshootingETroubleshooting quick list Printer health File will not print Printer front view Ink cartridges do not fire properly Firmware Download Procedure Upgrade/Printer Refresh Overall print quality is poor Calibrate cartridges Data Transfer No output when printing from Unix Application Software Difficulty generating prints ranging from a to D size Calling for Help Customer Technical Support