Xerox 3435DN manual Printing a network configuration, Configuring CentreWare is

Page 27

Printing a network configuration page

The network configuration page shows how the network interface card on your printer is configured.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Up/down arrow buttons until Network Info. appears and press OK.

3Press OK when Yes appears.

The network configuration page prints out.

Configuring 802.1x

Your printer has 802.1x protocol on its network. 802.1x is a security standard for port based network access control. It secures your network against unauthorized access by requiring authentication before network access and data transmission are allowed. There are 3 mutually exclusive options for 802.1x authentication.

To use 802.1x, take the following steps:

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Up/down arrow buttons until 802.1x appears and press OK.

3Press the Up/down arrow buttons until On appears and press OK.

4Press the Up/down arrow buttons until the desired authentication method appears.

EAP-MD5: EAP-MD5 (Extensible Authentication Protocol Message Digest algorithm 5) is a message hashing scheme between client and server to allow the transfer of user data in a secure fashion.

EAP-MSCHAPv2: EAP-MSCHAP (Extensible Authentication Protocol Microsoft version of the Challenge-Handshake Authentication Protocol). MSCHAP v2 is a one-way encrypted password, mutual authentication process. MS-CHAPv2 uses different hashing/encryption algorithms to encode the UserID and passwords.

PEAP: PEAP (Protected EAP).

5Enter user name and passcode using Up/down arrow button.

6Press OK to save the selection.

7Press Start/Stop to return to Standby mode.

Configuring CentreWare IS

Your printer can use CentreWare IS (Internet Services). To enable CentreWare IS, take the following steps:

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Up/down arrow buttons until CentreWare IS appears and press OK.

3Press the Up/down arrow buttons until On appears and press OK.

4.3 <Network setup>

Image 27
Contents Page Page Contents Specifications MaintenanceTroubleshooting Installing accessoriesSafety Electrical Safety Information Regulatory Information OpenSSL License Environmental Compliance Product Recycling and Disposal Introduction Special featuresFeatures Phaser 3435/DN Printer overviewFront view Rear view Control panel overview Finding more information Understanding the Status LEDClearance space Selecting a locationMenu overview System setupUsing control panel menus Accessing control panel menusLayout menu Information menuPaper menu Graphic menu System Setup menuEmulation menu PostScript Network menuChanging the display language Using toner save modeUsing the control panel button Printing a demoSupplied software Software overviewMac OS Printer driver featuresSystem requirements WindowsVia the control panel Network setupVia network administration programs Supported operating systemsRestoring the network configuration Configuring TCP/IPConfiguring EtherTalk Setting Ethernet speedPrinting a network configuration ConfiguringConfiguring CentreWare is Selecting print media Loading print mediaSupported sizes of paper Type Size Dimensions Weighta CapacitybGuidelines for selecting and storing print media Guidelines for special print mediaMedia type Guidelines Loading paper Changing the size of the paper in the tray Using the tray 1 or the optional trayLoad the paper with the side to be printed on facing up Using the multi-purpose trayTips on using the multi-purpose tray Using manual feed modeSelecting an output location Printing to the output tray Face downPrinting to the rear cover Face up Printing a document Canceling a print jobPrinting a document Canceling a print job Basic printingPrint cartridges Ordering supplies and accessoriesAccessories How to purchaseCleaning the inside of the printer MaintenanceCleaning the printer Cleaning the outside of the printerChecking the remaining toner Maintaining the print cartridgeOpen the front cover Redistributing print cartridgeReplacing the print cartridge Toner Low appears on the displayMaintenance parts Clearing the Toner Low Replace Toner messageItems Yield Average Tray TroubleshootingClearing paper jams Paper feed areaMulti-purpose tray Optional trayPaper exit area Around the print cartridgeDuplex jam Duplex unit areaTips for avoiding paper jams Understanding display messages Troubleshooting checklistSelf Diagnostic Message Meaning Suggested solutions LSU Motor ErrorOpen Heat Error Over Heat ErrorPrint cartridge-related messages Software Section. Try Solving general printing problemsCondition Possible cause Suggested solutions Select Xerox Phaser 3435 asSelect Download as Bit Image Advanced OptionsTurn on Print As Image from Solving print quality problems Characters Condition Suggested solutions BackScatter MisformedCommon PostScript problems Common Windows problemsCommon Macintosh problems Common Linux problemsDisconnect the power cord Installing accessoriesPrecautions when installing accessories Installing a memory DimmSetting the memory in the PostScript printer properties Specifications and Description SpecificationsPrinter specifications Printer specificationsIndex Windows Toner save mode, use Windows problems Software section Software section Contents Using Windows Postscript Driver Using Your Printer in Linux Installing Printer Software in Windows Installing Printer SoftwareInstalling Software for Local Printing Custom Installation Installing Printer Software in Windows Installing Software for Network Printing Custom Installation Installing Printer Software in Windows Removing Printer Software Reinstalling Printer SoftwareUsing SetIP Installing SetIPUsing SetIP Basic Printing Printing a DocumentSelect your printer driver from the Name drop-down list Printer Settings Printing to a file PRNSelect Printers and Faxes Select your printer driver icon Paper Tab Layout TabGraphics Tab Extras Tab Printer Tab Troubleshooting TabUsing a Favorite Setting Using HelpPrinting Multiple Pages on One Sheet of Paper N-Up Printing Advanced PrintingPrinting Booklets Printing PostersSelected Paper Size Printing on Both Sides of PaperPrinting a Reduced or Enlarged Document Fitting Your Document to aEditing a Watermark Using WatermarksUsing an Existing Watermark Creating a WatermarkCreating a New Page Overlay Using OverlaysWhat is an Overlay? Using a Page OverlayAdvanced Using Windows PostScript DriverChanging the Status Monitor Program Settings Using Utility ApplicationsUsing Printer Settings Utility Opening the Troubleshooting GuideCheck the Share this printer box Setting Up a Host ComputerSetting Up a Client Computer Sharing the Printer LocallyGetting Started Using Your Printer in LinuxInstalling the Unified Linux Driver Installing the Unified Linux DriverClick Uninstall Uninstalling the Unified Linux DriverDouble-clickUnified Driver Configurator on the desktop Using the Unified Driver ConfiguratorPrinters Configuration Opening the Unified Driver ConfiguratorPorts Configuration Configuring Printer PropertiesPrinting from Applications Printing FilesFile menu Click Continue Select Easy Install and click Install Using Your Printer with a MacintoshInstalling printer driver for Macintosh Uninstalling the printer driverSelect your printer name Setting Up the PrinterFor a Network-connected Macintosh For a USB-connected MacintoshClick Show Info Installable OptionsPrinting Printing a DocumentLayout Changing Printer SettingsDuplex Printing Printing Multiple Pages on One Sheet of PaperIndex