Reset Switch
Important: The LED will light red only in Load Control mode; never in Charge or Diversion mode (unless it is reversed upon reinstallation).
Reset Switch
Use the Reset Switch on the side of the chassis for the following conditions.
•To manually initiate battery equalization in Charge Control mode, press and hold the Reset Switch until the red and green LED start to flash.
•To manually suspend battery equalization in Charge Control mode, press and hold the Reset Switch until the red and green LED stop flashing.
•To reset following an error condition, press and release the Reset Switch.
•To reset following a
See “Reconnecting to Loads” for additional information about reconnecting to loads.
Reset Switch
Figure 3-3 Reset Switch
61 |