Cabletron Systems 9C300-1 manual External Ambient Temperature, Temperature Range LCD Display

Page 14

9C300-1 Environmental Module Operation

External Ambient Temperature

The 9C300-1 Environmental Module includes an external ambient temperature sensor. This sensor is located on the front of the Environmental Module, as shown in Figure 3-2.The ambient temperature is monitored and the results of the monitoring are available to the network manager via the LCD, as well as local and remote management.

	MMAC						EPIM
							STATUS
					9C300-1		ALARM	COM 1
									COM 2				ENTER
									COM 2
1	2	3	4	5	6	7	8	9	10	11	12	13	14

External ambient temperature sensor

Figure 3-2. External Ambient Temperature Sensor

Table 3-1lists the ambient temperature information available to the network manager.

Table 3-1. External Ambient Temperature

Temperature Range	LCD Display


6°C/43°F and below	COLD

7–12°C/44–54°F	COOL

13–32°C/55–90°F	NORM (normal)

33–38°C/91–101°F	WARM

39°C/102°F and above	HOT

3-2

Image 14

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page FCC Notice DOC NoticeContents Appendix a Epim Speciﬁcations Appendix B Uninterruptible Power Supply UPSChapter Speciﬁcations Using This Manual 9C300-1 Environmental ModuleOut-of-Band Management FeaturesSystem Cooling Flash Eeprom Environmental/Power MonitoringRelated Manuals Hot SwappingGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module 9C300-1 Environmental Module Operation Monitoring FunctionsExternal Ambient Temperature Temperature Range LCD DisplayFan Speed 9C300-1 Environmental Module and Fan TraySystem Voltages Internal Operating TemperatureSystem Humidity Humidity LCD DisplayLanview LEDs LED Color State DescriptionOut-of-Band Management COM1 and COM2 Ports Pin DescriptionEthernet Port Interface Module Epim LCD and KeypadSystem Screen Non-Interactive ModeNon-Interactive Mode Screens Utilization Screen Environment ScreenPower Screen System Banner ScreenInteractive Mode Interactive Mode ScreensAlarm Screen Main ScreenENV Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Power Supply Speciﬁc ScreenCommunications Screen Diagnostic Module Selection Screen Diagnostic Results ScreenBBU Screen Module Selection ScreenFault Module Speciﬁc ScreenModule Environment Screen Module Memory ScreenModule Backplane Screen Environmental Module Speciﬁc ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Safety ServicePhysical DimensionsWeight EnvironmentalEpim Speciﬁcations IntroductionEPIM-F1 and EPIM-F2 Parameter Typical Value Worst Worst Case BudgetEPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Connector Type GroundingEPIM-A and EPIM-X AUI Port Pin Number RepresentsEpim Speciﬁcations Uninterruptible Power Supply UPS Connecting a UPS to an EMUninterruptible Power Supply UPS Conﬁguring COM Port for UPSVerifying Conﬁguration Monitoring UPSUninterruptible Power Supply UPS