Cabletron Systems 9C300-1 manual Epim Specifications, Introduction

Page 39

Appendix A

EPIM Specifications

Introduction

The 9C300-1 Environmental Module provides a port for Cabletron Systems EPIMs. EPIMs let you connect to the main network using different media types. Cabletron Systems offers a variety of EPIMs whose specifications are explained in the following sections.

EPIM-T

The EPIM-T is an RJ-45 connector supporting UTP cabling. It has an internal Cabletron Systems TPT-T™ 10BASE-T Twisted Pair Transceiver.

The slide switch on the EPIM-T determines the crossover status of the cable pairs. If the switch is on the X side, the pairs are internally crossed over. If the switch is on the = side, the pairs are not internally crossed over. Figure A-1 shows the pinouts for the EPIM-T in both crossover positions.

Position X (crossed over)

1. RX+

5. NC

2. RX-

6. TX-

3. TX+

7. NC

4. NC

8. NC

 

 

Position = (not crossed over)

1. TX+

5.

NC

2. TX-

6.

RX-

3. RX+

7. NC

4. NC

8. NC

Figure A-1. EPIM-T Pinouts

A-1

Image 39
Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC NoticeContents Appendix B Uninterruptible Power Supply UPS Chapter SpecificationsAppendix a Epim Specifications 9C300-1 Environmental Module Using This ManualFeatures System CoolingOut-of-Band Management Hot Swapping Environmental/Power MonitoringRelated Manuals Flash EepromGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module OperationTemperature Range LCD Display External Ambient Temperature9C300-1 Environmental Module and Fan Tray Fan SpeedHumidity LCD Display Internal Operating TemperatureSystem Humidity System VoltagesLED Color State Description Lanview LEDsOut-of-Band Management Pin Description COM1 and COM2 PortsLCD and Keypad Ethernet Port Interface Module EpimNon-Interactive Mode Non-Interactive Mode ScreensSystem Screen Environment Screen Utilization ScreenSystem Banner Screen Power ScreenInteractive Mode Screens Interactive ModeMain Screen Alarm ScreenENV Power Supply Specific Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on ExitCommunications Screen Diagnostic Results Screen Diagnostic Module Selection ScreenModule Selection Screen BBU ScreenModule Specific Screen FaultModule Memory Screen Module Environment ScreenEnvironmental Module Specific Screen Module Backplane ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service SafetyEnvironmental DimensionsWeight PhysicalIntroduction Epim SpecificationsParameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector TypePin Number Represents EPIM-A and EPIM-X AUI PortEpim Specifications Connecting a UPS to an EM Uninterruptible Power Supply UPSConfiguring COM Port for UPS Uninterruptible Power Supply UPSMonitoring UPS Verifying ConfigurationUninterruptible Power Supply UPS