Cabletron Systems 9C300-1 manual

Page 3

Notice

Notice

Cabletron Systems reserves the right to make changes in speciﬁcations and other information contained in this document without prior notice. The reader should in all cases consult Cabletron Systems to determine whether any such changes have been made.

The hardware, ﬁrmware, or software described in this manual is subject to change without notice.

IN NO EVENT SHALL CABLETRON SYSTEMS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS MANUAL OR THE INFORMATION CONTAINED IN IT, EVEN IF CABLETRON SYSTEMS HAS BEEN ADVISED OF, KNOWN, OR SHOULD HAVE KNOWN, THE POSSIBILITY OF SUCH DAMAGES.

© Copyright November 1994 by:

Cabletron Systems, Inc.

35 Industrial Way

Rochester, NH 03867-0505

All Rights Reserved

Printed in the United States of America

Order Number: 9031155 November 1994

LANVIEW is a registered trademark and MMAC-Plusis a trademark of Cabletron Systems, Inc.

VT100 is a registered trademark of Digital Equipment Corporation.

Ethernet is a trademark of Xerox Corporation.

CompuServe is a registered trademark of CompuServe, Incorporated.

i

Image 3

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC NoticeContents Appendix B Uninterruptible Power Supply UPS Chapter SpeciﬁcationsAppendix a Epim Speciﬁcations 9C300-1 Environmental Module Using This ManualFeatures System CoolingOut-of-Band Management Hot Swapping Environmental/Power MonitoringRelated Manuals Flash EepromGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module OperationTemperature Range LCD Display External Ambient Temperature9C300-1 Environmental Module and Fan Tray Fan SpeedHumidity LCD Display Internal Operating TemperatureSystem Humidity System VoltagesLED Color State Description Lanview LEDsOut-of-Band Management Pin Description COM1 and COM2 PortsLCD and Keypad Ethernet Port Interface Module EpimNon-Interactive Mode Non-Interactive Mode ScreensSystem Screen Environment Screen Utilization ScreenSystem Banner Screen Power ScreenInteractive Mode Screens Interactive ModeMain Screen Alarm ScreenENV Power Supply Speciﬁc Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on ExitCommunications Screen Diagnostic Results Screen Diagnostic Module Selection ScreenModule Selection Screen BBU ScreenModule Speciﬁc Screen FaultModule Memory Screen Module Environment ScreenEnvironmental Module Speciﬁc Screen Module Backplane ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service SafetyEnvironmental DimensionsWeight PhysicalIntroduction Epim SpeciﬁcationsParameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector TypePin Number Represents EPIM-A and EPIM-X AUI PortEpim Speciﬁcations Connecting a UPS to an EM Uninterruptible Power Supply UPSConﬁguring COM Port for UPS Uninterruptible Power Supply UPSMonitoring UPS Verifying ConﬁgurationUninterruptible Power Supply UPS