Cabletron Systems 9C300-1 manual EPIM-F1 and EPIM-F2

Page 41

EPIM-F1 and EPIM-F2

Table A-2. Transmitter Power

	Parameter	Typical Value	Worst	Worst Case	Typical
	Parameter	Typical Value	Case	Budget	Budget
			Case	Budget	Budget


	50/125 ∝m	-13.0 dBm	-15.0 dBm	13.0 dB	17.5 dB
	ﬁber

	62.5/125 ∝m	-10.0 dBm	-12.0 dBm	16.0 dB	20.5 dB
	ﬁber

	100/140 ∝m	-7.0 dBm	-9.0 dBm	19.0 dB	23.5 dB
	ﬁber

	Error Rate	Better than 10-10

NOTE

The transmitter power levels and receive sensitivity levels listed are Peak Power Levels after optical overshoot. A Peak Power Meter must be used to correctly compare the values given above to those measured on any particular port. If Power Levels are being measured with an Average Power Meter, then 3 dBm must be added to the measurement to correctly compare those measured values to the values listed (i.e., -30.5 dBm peak = -33.5 dBm average).

A-3

Image 41

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page DOC Notice FCC NoticeContents Appendix a Epim Speciﬁcations Appendix B Uninterruptible Power Supply UPSChapter Speciﬁcations 9C300-1 Environmental Module Using This ManualOut-of-Band Management FeaturesSystem Cooling Related Manuals Environmental/Power MonitoringFlash Eeprom Hot SwappingGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module Monitoring Functions 9C300-1 Environmental Module OperationTemperature Range LCD Display External Ambient Temperature9C300-1 Environmental Module and Fan Tray Fan SpeedSystem Humidity Internal Operating TemperatureSystem Voltages Humidity LCD DisplayLED Color State Description Lanview LEDsOut-of-Band Management Pin Description COM1 and COM2 PortsLCD and Keypad Ethernet Port Interface Module EpimSystem Screen Non-Interactive ModeNon-Interactive Mode Screens Environment Screen Utilization ScreenSystem Banner Screen Power ScreenInteractive Mode Screens Interactive ModeMain Screen Alarm ScreenENV Power Supply Speciﬁc Screen Supplies Installed 2 PWR Redundancy Status 1 on 2 on ExitCommunications Screen Diagnostic Results Screen Diagnostic Module Selection ScreenModule Selection Screen BBU ScreenModule Speciﬁc Screen FaultModule Memory Screen Module Environment ScreenEnvironmental Module Speciﬁc Screen Module Backplane ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Service SafetyWeight DimensionsPhysical EnvironmentalIntroduction Epim SpeciﬁcationsParameter Typical Value Worst Worst Case Budget EPIM-F1 and EPIM-F2EPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Grounding Connector TypePin Number Represents EPIM-A and EPIM-X AUI PortEpim Speciﬁcations Connecting a UPS to an EM Uninterruptible Power Supply UPSConﬁguring COM Port for UPS Uninterruptible Power Supply UPSMonitoring UPS Verifying ConﬁgurationUninterruptible Power Supply UPS