Cabletron Systems 9C300-1 manual Utilization Screen, Environment Screen

Page 22

9C300-1 Environmental Module Operation

The Utilization Screen

The Utilization Screen, as shown in Figure 3-8,is the second screen of the non-interactive mode.

Line 1 displays the screen heading.

Line 2 displays the FDDI 1 and FDDI 2 bus utilization.

Line 3 displays the INB A and INB B bus utilization.

Line 4 displays the system status.

SYSTEM UTILIZATION

FDDI 1_ _ _ _ _ 100% FDDI 2 _ _ _ _ _100%

INB A _ _ _ _ _100% INB B _ _ _ _ _ 100%

SYSTEM STATUS NORMAL

Figure 3-8. The Utilization Screen

The Environment Screen

The Environment Screen, as shown in Figure 3-9,is the third screen of the non-interactive mode.

Line 1 displays the screen heading.

Line 2 displays the external temperature of the chassis in both Fahrenheit and Celsius and qualiﬁes the temperature as COLD, COOL, NORM (normal), WARM or HOT based on system parameters.

Line 3 displays the non-condensing humidity level of the chassis and qualiﬁes it as STATIC RISK, NORM (normal) or MOIST based on system parameters.

Line 4 displays the system status.

CHASSIS ENVIRONMENT

EXTERNAL TEMP xxx˚F xx˚C NORM

HUMIDITY xxx% NORM

SYSTEM STATUS NORMAL

Figure 3-9. The Environment Screen

3-10

Image 22

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page FCC Notice DOC NoticeContents Chapter Speciﬁcations Appendix B Uninterruptible Power Supply UPSAppendix a Epim Speciﬁcations Using This Manual 9C300-1 Environmental ModuleSystem Cooling FeaturesOut-of-Band Management Flash Eeprom Environmental/Power MonitoringRelated Manuals Hot SwappingGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module 9C300-1 Environmental Module Operation Monitoring FunctionsExternal Ambient Temperature Temperature Range LCD DisplayFan Speed 9C300-1 Environmental Module and Fan TraySystem Voltages Internal Operating TemperatureSystem Humidity Humidity LCD DisplayLanview LEDs LED Color State DescriptionOut-of-Band Management COM1 and COM2 Ports Pin DescriptionEthernet Port Interface Module Epim LCD and KeypadNon-Interactive Mode Screens Non-Interactive ModeSystem Screen Utilization Screen Environment ScreenPower Screen System Banner ScreenInteractive Mode Interactive Mode ScreensAlarm Screen Main ScreenENV Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Power Supply Speciﬁc ScreenCommunications Screen Diagnostic Module Selection Screen Diagnostic Results ScreenBBU Screen Module Selection ScreenFault Module Speciﬁc ScreenModule Environment Screen Module Memory ScreenModule Backplane Screen Environmental Module Speciﬁc ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Safety ServicePhysical DimensionsWeight EnvironmentalEpim Speciﬁcations IntroductionEPIM-F1 and EPIM-F2 Parameter Typical Value Worst Worst Case BudgetEPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Connector Type GroundingEPIM-A and EPIM-X AUI Port Pin Number RepresentsEpim Speciﬁcations Uninterruptible Power Supply UPS Connecting a UPS to an EMUninterruptible Power Supply UPS Conﬁguring COM Port for UPSVerifying Conﬁguration Monitoring UPSUninterruptible Power Supply UPS