Cabletron Systems 9C300-1 manual BBU Screen, Module Selection Screen

9C300-1 Environmental Module Operation

The BBU Screen

Select <BBU> from the System Screen, as shown in Figure 3-15,to view the status of the Battery Backup Units (BBUs). Figure 3-22shows the BBU Screen.

Line 1 displays the screen heading.

Line 2 displays BBU status (CHARGING, STANDBY or DISCHARGING) if BBUs are installed; however, if no BBUs are installed, the message NO BBU INSTALLED displays.

Line 3 displays the estimated amount of system run time stored in the BBUs if the system is running on a standard power source; or, if the system is running on BBUs, the amount of system run time remaining in the BBUs at the current power load.

BATTERY STATUS

BBU CHARGING

SYSTEM RUN TIME AT PWR LOSS xxx MINUTES <EXIT>

Figure 3-22. The BBU Screen

Select <EXIT> to return to the System Screen.

The Module Selection Screen

Select <MODULES> from the Main Screen, as shown in Figure 3-13,to display the chassis slot locations in which modules have been installed.

Line 1, as shown in Figure 3-23,displays the screen heading.

Lines 2 and 3 list all modules in the MMAC-Plus by slot number.

MODULE SELECTION

<EM> <1> <2> <3> <4> <5> <6> <7> <8> <9> <10> <11> <12> <13> <14>

<EXIT>

Figure 3-23. The Module Selection Screen

Select <EXIT> to return to the main System Screen.

3-18