Cabletron Systems 9C300-1 manual Diagnostic Module Selection Screen, Diagnostic Results Screen

Interactive Mode

The Diagnostic Module Selection Screen

Select <DIAGS> from the System Screen, as shown in Figure 3-15,to view the Diagnostic Module Selection screen.

Line 1, as shown in Figure 3-20,displays the screen heading.

Lines 2 and 3 show the chassis slot locations in which modules have been installed in the MMAC-Plus.

Line 4 displays Power Supply Units and BBUs configured in the MMAC-Plus. Diagnostic test results for these units can be viewed individually. The Diagnostic Results Screen displays the diagnostic test results for the selected modules. It provides an itemized list of failed tests only.

VIEW DIAG RESULTS ON

<EM> <1> <2> <3> <4> <5> <6> <7> <8><9> <10> <11> <12> <13> <14> <PS1> <PS2> <BBU1> <EXIT>

Figure 3-20. The Diagnostic Module Selection Screen

Select <EXIT> to return to the System Screen.

The Diagnostic Results Screen

The Diagnostic Results Screen, as shown in Figure 3-21,displays the results of failed tests for the modules selected on the Diagnostic Screen.

Line 1 displays the module(s) selected for diagnostics.

Lines 2 and 3 display failed test results; or, if no failures occurred, the message

ALL DIAGNOSTICS TESTS HAVE PASSED.

MODULE xx

Test Results (Left Blank if all pass)

or ALL MODULE DIAGNOSTICS TESTS HAVE PASSED

<MORE> <EXIT>

Figure 3-21. The Diagnostic Results Screen

Select <MORE> to view more failed tests for the current module.

Select <EXIT> to return to the Diagnostic Module Selection Screen.

3-17