Cabletron Systems 9C300-1 manual Conﬁguring COM Port for UPS, Uninterruptible Power Supply UPS

Page 48

Uninterruptible Power Supply (UPS)

	MMAC							EPIM
								STATUS	COM 1	COM 2
								ALARM
						9C3001
1	2	3	4	5	6	7	8	9	1 0	1	1 2	1 3	1 4

MMAC-Plus Chassis (Front View)

9 Pin D Connector Receptacle

Matrix UPS (Back View)

COM Ports

Figure B-1. Connecting EM to UPS

Conﬁguring COM Port for UPS

After the UPS has been connected to the COM2 port, the COM2 port must be conﬁgured for UPS Management. To conﬁgure the COM2 port for UPS Management, follow the steps below.

1.Connect the terminal or PC used for local management to the COM1 port on the Environmental Module (EM) and press RETURN until the Slot Selection Screen displays.

2.At the Slot Selection Screen, enter 0 (zero) to display the EM Conﬁguration Screen.

3.At the EM Conﬁguration Screen, cursor to the Application Field for the COM2 port.

4.Using the space bar, toggle to the UPS option.

5.Using the tab key, tab to the SAVE option and press RETURN.

If you need additional information about conﬁguring the COM ports, refer to the Local Management User’s Guide.

B-2

Image 48

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page FCC Notice DOC NoticeContents Appendix B Uninterruptible Power Supply UPS Chapter SpeciﬁcationsAppendix a Epim Speciﬁcations Using This Manual 9C300-1 Environmental ModuleFeatures System CoolingOut-of-Band Management Environmental/Power Monitoring Related ManualsFlash Eeprom Hot SwappingGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module 9C300-1 Environmental Module Operation Monitoring FunctionsExternal Ambient Temperature Temperature Range LCD DisplayFan Speed 9C300-1 Environmental Module and Fan TrayInternal Operating Temperature System HumiditySystem Voltages Humidity LCD DisplayLanview LEDs LED Color State DescriptionOut-of-Band Management COM1 and COM2 Ports Pin DescriptionEthernet Port Interface Module Epim LCD and KeypadNon-Interactive Mode Non-Interactive Mode ScreensSystem Screen Utilization Screen Environment ScreenPower Screen System Banner ScreenInteractive Mode Interactive Mode ScreensAlarm Screen Main ScreenENV Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Power Supply Speciﬁc ScreenCommunications Screen Diagnostic Module Selection Screen Diagnostic Results ScreenBBU Screen Module Selection ScreenFault Module Speciﬁc ScreenModule Environment Screen Module Memory ScreenModule Backplane Screen Environmental Module Speciﬁc ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Safety ServiceDimensions WeightPhysical EnvironmentalEpim Speciﬁcations IntroductionEPIM-F1 and EPIM-F2 Parameter Typical Value Worst Worst Case BudgetEPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Connector Type GroundingEPIM-A and EPIM-X AUI Port Pin Number RepresentsEpim Speciﬁcations Uninterruptible Power Supply UPS Connecting a UPS to an EMUninterruptible Power Supply UPS Conﬁguring COM Port for UPSVerifying Conﬁguration Monitoring UPSUninterruptible Power Supply UPS