Cabletron Systems 9C300-1 manual Interactive Mode Screens

Page 24

9C300-1 Environmental Module Operation

Interactive Mode

The LCD enters this mode upon installation. This mode allows user input through the ﬁve-function keypad to navigate through MMAC-Plus status screens, and to make menu selections.

Press any button on the keypad to enter this mode from the non-interactive mode. Once past the Main screen, the Interactive Mode is maintained for three minutes without a keypad entry before returning to the non-interactive mode.

Interactive Mode Screens

This section describes the LCD screens that display in the Interactive Mode. The Interactive Mode screen ﬂow, as shown in Figure 3-12,provides a representation of the Interactive Mode screen structure hierarchy.

Main Screen

System

Alarms

Modules

Screen Contrast

Pwr

Environment

Diag

Com

BBU

Modules Selection Screen

Screen Adjust

Results

Pwr

Supply

Speciﬁc

Modules/Environmental Module Speciﬁc Screen

Environment

Memory

Backplane

Figure 3-12. Interactive Mode Screen Flow

3-12

Image 24

Contents MMAC-Plus 9C300-1 Environmental Module User’s Guide Page Page FCC Notice DOC NoticeContents Appendix B Uninterruptible Power Supply UPS Chapter SpeciﬁcationsAppendix a Epim Speciﬁcations Using This Manual 9C300-1 Environmental ModuleFeatures System CoolingOut-of-Band Management Environmental/Power Monitoring Related ManualsFlash Eeprom Hot SwappingGetting Help Installing the 9C300-1 Environmental Module Installing the 9C300-1 Environmental ModuleInstalling the 9C300-1 Environmental Module 9C300-1 Environmental Module Operation Monitoring FunctionsExternal Ambient Temperature Temperature Range LCD DisplayFan Speed 9C300-1 Environmental Module and Fan TrayInternal Operating Temperature System HumiditySystem Voltages Humidity LCD DisplayLanview LEDs LED Color State DescriptionOut-of-Band Management COM1 and COM2 Ports Pin DescriptionEthernet Port Interface Module Epim LCD and KeypadNon-Interactive Mode Non-Interactive Mode ScreensSystem Screen Utilization Screen Environment ScreenPower Screen System Banner ScreenInteractive Mode Interactive Mode ScreensAlarm Screen Main ScreenENV Supplies Installed 2 PWR Redundancy Status 1 on 2 on Exit Power Supply Speciﬁc ScreenCommunications Screen Diagnostic Module Selection Screen Diagnostic Results ScreenBBU Screen Module Selection ScreenFault Module Speciﬁc ScreenModule Environment Screen Module Memory ScreenModule Backplane Screen Environmental Module Speciﬁc ScreenEnvironmental Module Environment Screen LCD Contrast Adjustment Screen 9C300-1 Environmental Module Operation Safety ServiceDimensions WeightPhysical EnvironmentalEpim Speciﬁcations IntroductionEPIM-F1 and EPIM-F2 Parameter Typical Value Worst Worst Case BudgetEPIM-F1 and EPIM-F2 EPIM-F3 Parameter Typical Minimum Maximum Connector Type GroundingEPIM-A and EPIM-X AUI Port Pin Number RepresentsEpim Speciﬁcations Uninterruptible Power Supply UPS Connecting a UPS to an EMUninterruptible Power Supply UPS Conﬁguring COM Port for UPSVerifying Conﬁguration Monitoring UPSUninterruptible Power Supply UPS