Cabletron Systems 9C300-1 manual Non-Interactive Mode Screens, System Screen

Non-Interactive Mode

Non-Interactive Mode

The LCD defaults to this mode if there is no user input within 60 seconds of installation of the Environmental Module or system start-up.

Non-Interactive Mode Screens

This section describes the LCD screens that display in the non-interactive mode. The LCD scrolls through different status screens (depending on MMAC-Plus configuration), displaying each screen for a period of 7 seconds; or, until user input is sensed on the keypad.

Line 4 of each screen displays any active alarm conditions that exist within the system. If no alarm conditions exist, the line displays “SYSTEM STATUS NORMAL.”

If an alarm condition exists, line 4 displays a message describing the alarm for 5 seconds. The screen then displays a message stating how many alarms are present in the alarm queue, “XX ALARMS PENDING” and the ALARM LED on the front of the Environmental Module turns yellow or red indicating unread alarms in the queue.

The System Screen

The System Screen, as shown in Figure 3-7,is the first screen of the non-interactive mode.

Lines 1 and 2 display the MMAC-Plus chassis Internet Protocol (IP) address and Media Access Control (MAC) address.

Line 3 displays the current chassis hardware revision and serial number.

Line 4 displays the system status.

CHASSIS IP ADDRESS xxx.xxx.xxx.xxx

CHASSIS MAC ADDRESS xx-xx-xx-xx-xx-xx

CHASSIS HW REV xxx SN xxxxxxxxxxxx

SYSTEM STATUS NORMAL

Figure 3-7. The System Screen

3-9