Extron electronic DVS 304 manual Wiring the RJ-45

IRGB (RGBHV, RGBS, RGsB) or HD component (R-Y, Y, B-Y) video BNC outputs —

Connect cables from a display device to these BNCs for a scaled or pass-through RGB or a scaled component video output. The output can be scaled to 69 different output rates (see table on page 15).

NOTES: RGB pass-through is available on analog outputs only. The DVI output is

disabled for RGB pass-through.

RGBHVRGBS\RGBcvS

R	G	B	R	G	B
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H/	V		H/	V
			HV
HV
	RGsB		Component Video (Y, R-Y, B-Y)
R	G	B	R	G	B
/R-Y	/Y	/B-Y	/R-Y	/Y	/B-Y
H/	V		H/	V
HV			HV

Figure 5. RGB Cabling

(DVS 304 models only) RGB or HD component (R-Y, Y, B-Y) 15-pin HD video output — Connect an RGB video display or HD component video display to this HD 15-pin connector.

NOTE: Outputs are buffered and can be connected simultaneously to two different displays. The sync and video formats will be the same for both outputs.

(DVS 304 DVI models only) DVI (digital and analog) output — Connect a suitable display device to this DVI-I connector for scaled RBG or component video digital and analog outputs.

JReset button and LED — Using an Extron Tweeker, pointed stylus, or ballpoint pen, press this recessed button for manual resets. The unit has four modes of reset (see

“Resetting the Unit” later in this chapter for additional information). The green LED flashes to show the reset mode indicators and that power is on.

KLAN connector — Plug an RJ-45 jack into this socket to connect the unit to a computer network. Use a patch cable to connect to a switch, hub, or router. See figure 2-6 for wiring information.

LAN Activity LED — A blinking yellow LED indicates LAN activity. Link LED — The green LED lights to indicate a good LAN connection.

Pins:

12345678

Insert Twisted

Pair Wires

RJ-45

Connector

	T568A	T568B
Pin	Wire color	Wire color
1	White-green	White-orange
2	Green	Orange
3	White-orange	White-green
4	Blue	Blue
5	White-blue	White-blue
6	Orange	Green
7	White-brown	White-brown
8	Brown	Brown

NOTE: If you are using Enhanced Skew-Free™A/V cable, use the TIA/EIA T568A standard only.

Figure 6. Wiring the RJ-45

DVS 304 Series • Cabling 7