Extron electronic DVS 304 manual Input 1 video type, Input 2 video type, Input 3 video type

Input 1 video type

Input 1 can only input composite video, other video types are not selectable.

Input 2 video type

Rotate either the Adjust horizontal ([) or Adjust vertical ({) knob while in the Input 2 submenu to select the appropriate video format (composite, S-video, YUVi, YUVp/HDTV, YUV Auto) for input 2.

When input 2 is set to YUV Auto, the scaler detects if YUVi or YUVp/HDTV is applied and sets the input accordingly. The default is YUVi video.

Input 3 video type

Input 3 can input only S-video, no other video types are selectable for this input. Using the Input Configuration menu.

Input 4 video type

Rotate the Adjust horizontal ([) or vertical ({) knobs while in the Input 4 submenu to select the appropriate video format (composite, S-video, RGBcvS, YUV, YUVp/HDTV, RGB scaled, RGB pass-through, Auto detect).

NOTE: RGB pass-through signals (at the native rate without additional processing) are available on analog outputs only. The DVI output is disabled for RGB pass-

through.

For DVS 304 DVI models, input 4 has an EDID emulation feature. See table on page 15 for EDID values.

When input 4 is set as “auto detect”, the scaler will switch to the new configuration whenever it detects an input type change. The default is RGB scaled.

SDI input (SDI IN)

Rotate either the Adjust horizontal ([) knob or Adjust vertical ({) knob while in the SDI Input submenu to select the input # for the SDI input. The SDI input can be assigned to inputs 1, 2, 3, 4, or none (*). The default is none.

NOTE: When the SDI input is no longer assigned to an input, either because it has been assigned to a new input or is set to “none”, the input reverts to the last

video type that was assigned to it.

SDI de-interlacer options

Rotate either the Adjust horizontal ([) or Adjust vertical ({) knob while in the SDI Deinter submenu to set the appropriate de-interlacing method (Standard or Flip). If the SDI input is displayed with a significant amount of jaggies, use this setting to flip the odd and even fields when de-interlacing the incoming SDI signal. The default is Standard.

DVS 304 Series • Operation 13