ATTO Technology 1500D/E, 1550D/E operation manual ISNSServer, MultiTargetMode

Page 47

iSNSServer

Specifies whether the IP address of a valid iSNS server from which the iPBridge will attempt iSCSI initiator discovery. Setting to 0.0.0.0 will disable iSNS server lookup.

Default: 0.0.0.0

Set syntax: set iSNSServer [xxx.xxx.xxx.xxx] Requires a SaveConfiguration command Get syntax: get iSNSServer

MultiTargetMode

Enables/disables iSCSI multiple target mode addressing on the iPBridge. If enabled, all previous maps will be deleted. In verbose mode, overwriting a map requires secondary confirmation of the action.

Set syntax: set MultiTargetMode [enabled disabled]

Get syntax: get MultiTargetMode

38 Configuration: CLI

Image 47

Contents IPBridgeTM 1500D/E IPBridgeTM 1550D/E Page Page Contents Connecting Scsi devices to the Scsi port Serial port configuration commands Mapping commands Term Definition GlossaryIntelligent Bridging Architecture, the engine Introduction IPBridge 1550 features Setting up the iPBridgeIPBridge1500 features Scsi Possible SAN/NAS ConfigurationAtto iPBridge 1500E Pin outs of the RJ11 connector, part number CBL-0911-001Exhibit 1.1-1 iPBridge 1500E board layout Installation instructionsAtto iPBridge 1500D Exhibit 1.2-1 iPBridge 1500D back panel Atto iPBridge 1550E Exhibit 1.3-1 iPBridge 1550E board layout Atto iPBridge 1550D Exhibit 1.4-1 iPBridge 1550D back panel To set Scsi port bus speed and transfer rates Connecting Scsi devices to the Scsi portTo connect Scsi devices to the Atto iPBridge Examples CablingCable types To find the iPBridge Configuring the iPBridgeConnecting using the GbE port Select Internet Options Using Atto ExpressNAVConnecting using the serial port To optimize ExpressNAV in Internet ExplorerEnter Using TelnetTo connect using Telnet Installation Configuration Managing the iPBridge Change default username, passwordScsi configuration To change the default administrator passwordMapping Ethernet port configurationISCSI configuration OEM configuration servicesTo open an ExpressNAV session Serial Port ConfigurationExpressNAV provides web-based interface StatusRestart Firmware Bridge ConfigurationAdvanced CLI Configuration To use the Advanced ConfigurationCLI provides ASCII-based interface Get Set Command Parameter 1 ParameterCommand conventions Configuration & Management CLI Command Defaults Example CLI commands summaryOEM configuration file Defaults Limits General use commands VerboseMode From information commands. Choices are enabled or disabledDiagnostic commands SCSITargets CLI Error MessagesRouteDisplay SCSIPortListMaintenance commands Configuration CLI Scsi configuration commands SpeedWrite SerialPortEcho Serial port configuration commandsSerialPortBaudRate Configuration CLI Ethernet commands ReadOnlyUsername ReadOnlyPasswordISCSI commands MultiTargetMode ISNSServerRoute Mapping commandsAutoMap Configuration CLI Privileged OEM configuration services VendorID OEM Config file supported commandsModelNumber ProductIDNode names Single target modeUse Command Line Interface Mapping devicesMapping single vs. multiple target mode Use the ExpressNAV interface Multiple target modeTo remove an iSCSITarget Example\bridgefirmware\I1500110.ima Updating firmwareTo use FTP over GbE to flash new firmware into the iPBridge Configuration & Management firmware update Appendix a Safety standards and compliances European Standards Atto iPBridge 1500E FC Rack Enclosures with Power SuppliesPWRA-0000-FRUPower Module for Atto FC Rack System Atto iPBridge 2500CCables/SCSI AccessoriesAppendix C Contact Atto Technology, Inc