ATTO Technology 1500D/E, 1550D/E operation manual Introduction

Page 9

Term

Definition

LUN

Logical Unit Number: a SCSI identifier of a device

NAS

Network Attached Storage: storage elements connected to a network to provide

 

file access services to computer systems; an NAS Storage Element includes an

 

engine to implement the file services and one or more devices to store data;

 

NAS elements may be attached to any type of network; an NAS host system

 

uses a file system device driver to access data and NAS systems interpret these

 

commands to execute the necessary internal file and device I/O operations

SCSI

Small Computer Systems Interface: a processor-independent standard for

 

system-level interface between a computer and intelligent devices including hard

 

disks, floppy disks, CD-ROM, printers, scanners, etc.

SNMP

Simple Network Management Protocol: a standard for monitoring and managing

 

systems and devices in a network; data is defined by a MIB; functions supported

 

include the request and retrieval of data

Tape Window

A fixed-size parameter indicating the maximum data length that can be written to

 

a tape in one Data Mover action; once the tape window is reached, the Data

 

Mover will pause until writes occur and the tape window becomes available.

TCP/IP

Abbreviation for the basic communication protocols used on the Internet

 

including Transmission Control Protocol (TCP), Internet Protocol (IP), File

 

Transfer Protocol (FTP), Simple Mail Transfer Protocol (SMTP) and Telnet.

Introduction

Image 9
Contents IPBridgeTM 1500D/E IPBridgeTM 1550D/E Page Page Contents Connecting Scsi devices to the Scsi port Serial port configuration commands Mapping commands Glossary Intelligent Bridging Architecture, the engineTerm Definition Introduction Setting up the iPBridge IPBridge1500 featuresIPBridge 1550 features Scsi Possible SAN/NAS ConfigurationAtto iPBridge 1500E Pin outs of the RJ11 connector, part number CBL-0911-001Exhibit 1.1-1 iPBridge 1500E board layout Installation instructionsAtto iPBridge 1500D Exhibit 1.2-1 iPBridge 1500D back panel Atto iPBridge 1550E Exhibit 1.3-1 iPBridge 1550E board layout Atto iPBridge 1550D Exhibit 1.4-1 iPBridge 1550D back panel Connecting Scsi devices to the Scsi port To connect Scsi devices to the Atto iPBridgeTo set Scsi port bus speed and transfer rates Cabling Cable typesExamples Configuring the iPBridge Connecting using the GbE portTo find the iPBridge Connecting using the serial port Using Atto ExpressNAVTo optimize ExpressNAV in Internet Explorer Select Internet OptionsUsing Telnet To connect using TelnetEnter Installation Configuration Scsi configuration Change default username, passwordTo change the default administrator password Managing the iPBridgeISCSI configuration Ethernet port configurationOEM configuration services MappingExpressNAV provides web-based interface Serial Port ConfigurationStatus To open an ExpressNAV sessionAdvanced CLI Configuration Bridge ConfigurationTo use the Advanced Configuration Restart FirmwareGet Set Command Parameter 1 Parameter Command conventionsCLI provides ASCII-based interface Configuration & Management CLI Command Defaults Example CLI commands summaryOEM configuration file Defaults Limits General use commands VerboseMode From information commands. Choices are enabled or disabledDiagnostic commands RouteDisplay CLI Error MessagesSCSIPortList SCSITargetsMaintenance commands Configuration CLI Scsi configuration commands SpeedWrite Serial port configuration commands SerialPortBaudRateSerialPortEcho Configuration CLI Ethernet commands ReadOnlyUsername ReadOnlyPasswordISCSI commands MultiTargetMode ISNSServerMapping commands AutoMapRoute Configuration CLI Privileged OEM configuration services ModelNumber OEM Config file supported commandsProductID VendorIDUse Command Line Interface Single target modeMapping devices Node namesMapping single vs. multiple target mode Use the ExpressNAV interface Multiple target modeTo remove an iSCSITarget ExampleUpdating firmware To use FTP over GbE to flash new firmware into the iPBridge\bridgefirmware\I1500110.ima Configuration & Management firmware update Appendix a Safety standards and compliances European Standards PWRA-0000-FRUPower Module for Atto FC Rack System FC Rack Enclosures with Power SuppliesAtto iPBridge 2500C Atto iPBridge 1500ECables/SCSI AccessoriesAppendix C Contact Atto Technology, Inc