Sharp MX-M160D Selected paper size, Paper misfeed has occurred, Paper is not loaded properly

TROUBLESHOOTING AND MAINTENANCE

Problem		Cause and solution	Page
	The original was placed in the wrong position.		45
	→	Place the original correctly.
The paper size used for the	An appropriate ratio was not used for the size of the original
	and the size of the paper.
copy is different from the			52
	→	Press the [AUTO IMAGE] key to select the appropriate copy ratio based
selected paper size
		on the original and copy sizes.
(part of the image is cut off
or too much of the page is	The size of paper loaded in the tray was changed without
blank).	changing the tray's paper size setting.		21
	→ The size of the paper loaded in the tray is different from the tray's paper
		size setting. Set the tray's paper size setting to the same orientation/size
		as the paper loaded in the tray.
	The size or weight of the paper being used is not within the
	specified range.		18
Wrinkles appear in the	→ Use copy paper within the specified range.
paper or the image
	The paper is curled or damp.
disappears in places.
	→ Replace it with dry copy paper. During periods when the machine is not		–
		used for a long time, remove the paper from the tray and store it in a dark
		place in a bag to prevent moisture absorption.
	A paper misfeed has occurred.		29
	→	See "REMOVING MISFEEDS" to remove the paper misfeed.
	The size or weight of the paper being used is not within the
	specified range.		18
	→ Use copy paper within the specified range.
	The paper is curled or damp.
	→ Replace it with dry copy paper. During periods when the machine is not		–
		used for a long time, remove the paper from the tray and store it in a dark
		place in a bag to prevent moisture absorption.
	Paper is not loaded properly.		18
	→	Make sure the paper is properly loaded.
	A piece of paper remains in the machine (after a paper
	misfeed was removed)		29
	→ Remove all pieces of misfed paper.
Paper misfeed.	Too much paper is loaded in the tray.		19
	→ If the stack of paper is higher than the indicator line on the tray, remove
		some of the paper and reload so that the stack does not exceed the line.
	Several sheets of paper stick together.		19
	→	Fan the paper well before loading it.
	The guides on the bypass tray do not match the width of the
	paper.		20
	→ Adjust the bypass guides to the size of the loaded paper.
	The bypass tray extension is not pulled out.		20
	→	When loading a large size of paper, pull out the bypass tray extension.
	The bypass paper feed roller is dirty.		37
	→	Clean the roller.
	A5 (5-1/2" x 8-1/2") paper is loaded in tray 2 or in the
	250-sheet or 2 x 250-sheet paper feed unit.		18
	→	A5 (5-1/2" x 8-1/2") size paper must be loaded in tray 1 or the bypass
		tray.

26