Sharp MX-M160D, MX-M200D operation manual No data are available

Page 98

MATERIAL SAFETY DATA SHEET

Page : 4/4

Date Issued : May. 1, 2008

MSDS No. F-31651

Chronic Effect : In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures.

12.ECOLOGICAL INFORMATION

No data are available.

13.DISPOSAL CONSIDERATIONS

Waste from Residues

: Waste material may be dumped or incinerated under conditions which meet all federal,

 

state and local environmental regulations.

Contaminated Packaging : Waste may be disposed or incinerated under conditions which meet all federal, state

 

and local environmental regulations.

 

 

14.TRANSPORT INFORMATION

 

UN Classification

: None

 

Not classified as hazardous for transport.

15.REGULATORY INFORMATION

 

US Information

 

 

TSCA(Toxic Substances Control Act)

:

All chemical substances in this product comply with all applicable rules or order under TSCA.

SARA(Superfund Amendments and Reauthorization Act) Title III

302 Extreme Hazardous Substance : None

311/312 Hazard Classification

: None

EU Information

 

 

1999/45/EC and 67/548/EEC

 

Symbol & Indication

 

: Not required

R-Phrase

 

: Not required

76/769/EEC

 

: All chemical substances in this product comply with all applicable rules or

 

 

order under 76/769/EEC.

16.OTHER INFORMATION

 

 

NFPA Rating (USA)

: Health=1 Flammability=1 Reactivity=0

WHMIS Legislation (Canada) : This product is not a controlled product. References

IARC(1996) : IARC monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol. 65, Printing Process And Printing Inks, Carbon Black and Some Nitro Compounds, Lyon, pp.149-261 H.Muhle, B.Bellmann, O.Creutzenberg, C.Dasenbrock, H.Ernst, R.Kilpper, J.C.MacKenzie, P.Morrow, U.Mohr,

S.Takenaka, and R.Mermelstein(1991) Pulmonary Response to Toner upon Chronic Inhalation Exposure in Rats. Fundamental and Applied Toxicology 17, pp.280-299.

The information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. However, all materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not guarantee that these are the only hazards which exist.

96

Image 98
Contents Part 1 General Information Part 2 Copier OperationWarranty EMC this machine and peripheral devicesPart 1 General Information Trademark acknowledgments MX-M200D Product Configurations250-sheet paper feed unit AR-D35 Contents Margin shift XY zoom copyingRotation copy A Copy Erase copyFollow the cautions below when using this machine Laser Information For EuropeInstallation Requirements Environmental InformationMeaning of R in original and paper size indications Software setup guideManuals Provided with the Product Conventions used in this manualMain Features Environment and people friendly design Fax function optionNetwork connection option Part Names and Functions Side cover Document cover when installedFusing unit paper guide Open to remove misfed paper Side cover handleOperation Panel Copy Ratio key Start key / indicatorPaper Select key Auto Image keyDisplay base screen Example Copy modeOperation in COPY, PRINT, SCAN, and FAX Modes Icons appearing in the special function icon displayPower OFF Turning the Power on and OFFPower on Power save modesPaper Default settingsLoading Paper Paper that can be used for automatic 2-sided printingLoading paper in a tray Loading PaperSpecial paper Open the bypass tray EnvelopesModes Changing the Paper Size Setting of a TraySET A4R SETPaper Size SET Disabling Enabling Auto Tray SwitchingAuto Tray Switching Using Auditing Mode Auditing ModeNumber of Accounts in Auditing Mode When the copy job is finished, press the ACC.#-C keyTroubleshooting and Maintenance Troubleshooting MACHINE/COPYING ProblemsPaper is not loaded properly Selected paper sizePaper misfeed has occurred Paper misfeed Too much paper is loaded in the trayAutomatically selected or Original is curled or foldedOriginal has many solid black areas Original size is not Original is smaller than A5 5-1/2 x 8-1/2 sizeMB of expansion memory Indicators and Display MessagesMessage Action Remove the misfed original Removing MisfeedsOriginal Misfeed in the SPF Section aMisfeed in the Bypass Tray Section COpen the front cover Misfeed in the MachineMisfeed in a Close the front cover and the side coverMisfeed in B Misfeed in Tray Misfeed in CGently close the side cover Open the side cover Gently push tray 2 into the machineRemove the misfed paper 250-sheet paper feed unit AR-D35Replacing the Toner Cartridge Close the front coverChecking the Total Output Count An A3 or 11 x 17 page is counted as two pagesCleaning the Bypass Tray Paper Feed Roller Cleaning the MachineCleaning the Document Glass SPF/DOCUMENT Cover Cleaning the Transfer Charger PositionSelect Display Contrast with the or key Adjusting the Display ContrastAdjust the contrast with the or key Optional Equipment Sheet Paper Feed Unit / 2 X 250-SHEET Paper Feed Unit SpecificationsReversing Single Pass Feeder / Single Pass Feeder Store the supplies in a location that is Storage of SuppliesProper Storage Store paper in the wrapper and lying flatPart 2 Copier Operation Page Close the SPF Normal CopyingCopying from the document glass Make sure that the desired paper tray is selectedPress the Start key to begin copying Stream feeding modeCopying from the SPF Copy will be delivered toCopying books or originals with folds or creases Auto paper select modeRemoving the document cover Originals that can be used in the SPFText/photo Making a Copy Darker or LighterAuto TextImportant note when making a large number of copies Setting the Number of CopiesAuto tray switching Selecting the TrayORIG. Size Enter Selecting the Original SizeORIG. Size Enter Inch Select ORIG. Size Enter from the menu with the or keyOKORIG. Size Enter EnterExtra ExtraPress the Paper Select key to select the desired tray Reducing or Enlarging a CopyAutomatic Ratio Selection Press the Auto Image keyKey Decrease the ratio in increments of 1% Key Select a larger preset ratioKey Select a smaller preset ratio Key Increase the ratio in increments of 1%Special Function OkadjustXY Zoom XY ZoomSet the vertical ratio with the , , , or keys AdjustOFF Vertical ratio can now be selectedOriginal → Paper TWO-SIDED CopyingTWO-SIDED Copying One-sided original → Two sidesBinding Change OFF TWO-SIDED Copying of ONE-SIDED OriginalsCopy ModeCopy Mode Binding Change on To stop copying in the middle Select 2 to 2 with the or key, or with the 2-SIDED Copy keySet the number of copies and press Start key Copy Mode Select 2 to 1 with the or key, or with the 2-SIDED Copy keyVertically-oriented TWO-SIDED Copies Using the Bypass TrayPlace original B as shown below OriginalOkoff Dual page CopySpecial Checkmark appearsReplace the previous originals and press the Start key Interrupting a Copy RUNPress the Interrupt key Copies of multiple original pages can collated into sets Sort ModeRotating the Image 90 Degrees Sort No sortNo Sort Offset function enabled Offset function disabledSort Press the Output keyPress the Paper Select key to select the desired paper tray 1 copy layoutsPattern BorderAN Okadjust Dual Erasing Shadows around Edges of a CopyErase EdgeSelect the erasure width with the or key Card Shot Card ShotModes Card ShotFront side of the card is scanned Copies/min 2 x 11R A4, B5, A5 8-1/2 x SpecificationsCopies/min A4R 8-1/2 x 11R 25%, 50%, 64%, 77%, 95%, 100%, 121%, 129%, 141%, 200%, 400%Output tray specifications AppendixProgramming AN Administrator Password Purpose of the System SettingsPrograms for Copy Mode Programming AN Administrator Password Change Admin PWSystem Settings List Program nameCopier Using the System SettingsSettings Reset 1 ACC Auditing ModeReset Account Account ControlDelete Change ACC. # ControlACC. # Control Single ACC. Limit Cancel Jobs of Invalid AccountsAccount Limit ACC. # SecurityDevice Control Waiting Copy Lamp SettingUSB2.0 Mode Offset FunctionOperation Setting KEY Touch Sound Disable Auto KEY RepeatDisable Paper Size SET Keys Touch Sound AT Initial PointPreheat Mode Auto Power SHUT-OFFAuto Power SHUT-OFF Timer Energy SaveCopy Settings Sort Auto Select Default Exposure Rotation CopyStream Feeding Disable Auto Paper Selection Resolution in AUTO/TEXT ModePhoto Mode Default Disable 2-SIDED CopyMaterial Safety Data Sheet Exposure Controls / Personal Protection Physical and Chemical Properties Ecological Information Supplier Identification Hazards Identification Physical and Chemical Properties No data are available Symbols / Numbers IndexReducing or enlarging a copy TroubleshootingNormal copying 13, 31Copying, starting TroubleshootingConvenient copy functions Two-sided copies of two-sided originals100 Administrator Password Number Factory Setting 102 103 Other Countries outside the EU Sharp Electronics Europe GmbH Sonninstraße 3, D-20097 HamburgMX-M160D/MX-M200D