Sharp AL-1670 operation manual Material Safety Data Sheet

Page 67

S H A R P

Date Issued:Nov. 1, 1998

MATERIAL SAFETY DATA SHEET

MSDS No. F-00841

Section 1. Product Identification

Product:

AL-160TD (Black Toner)

Section 2. Supplier’s Name and Address

Sharp Corporation

22-22 Nagaike-cho, Abeno-ku, Osaka, Japan

Local suppliers are listed below. Please contact the nearest supplier for additional information.

(Country)

(Name and Telephone Number)

 

 

 

U.S.A.

Sharp Electronics Corporation

 

 

Telephone number for information:

1-800-237-4277

 

Emergency telephone number:

1-800-255-3924

 

 

 

Canada

Sharp Electronics of Canada Ltd.

 

 

Telephone number for information:

905-890-2100

 

Emergency telephone number:

1-800-255-3924

 

 

 

United Kingdom

Sharp Electronics (U.K.) Ltd.

 

 

Telephone number for information:

01923-474013

 

 

 

Section 3. Ingredients

Ingredients

CAS No. Proportion OSHA PEL

ACGIH TLV Other Limits

Styrene-Acrylate copolymer

 

29497-14-1

> 88 %

Not listed

Carbon black

 

1333-86-4

< 6.0%

3.5mg/m3

Iron oxide

 

1309-38-2

< 4.5%

Not listed

Metal Complex dye

109125-51-1

< 1.5%

0.5mg/m3

 

109125-50-0

 

 

 

84179-66-8

 

 

Not listed

None

3.5mg/m3

None

Not listed

None

0.5mg/m3

None

Section 4. Hazardous Identification (Emergency Overview)

Toner is a fine, black powder possessing no immediate hazard. There are no anticipated carcinogenic effects from exposure based on animal tests performed using toner. When used as intended according to instructions, studies do not indicate any symptoms of fibrosis will occur.

Section 5. Health Hazard Data

Route(s) of Entry:

Inhalation?

Skin?

Ingestion?

 

Yes

No

Possible but very unusual.

Health Hazards: Acute oral toxicity ------- LDL0 of this toner is over 2,000mg/kg.

Mutagenicity -------------- The result of Ames test is negative.

Carcinogenicity: In 1996 the IARC reevaluated carbon black as a Group 2B carcinogen (possible human carcinogen). This classification is given to chemicals for which there is inadequate human evidence, but sufficient animal evidence on which to base an opinion of carcinogenicity. The classification is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung. Studies performed in animal models other than rats did not show any association between carbon black and lung tumors. Moreover, a two-year cancer bioassay using a typical toner preparation containing carbon black demonstrated no association between toner exposure and tumor development in rats.

Chronic Effect: In a study in rats of chronic inhalation exposure to a typical toner, a mild to moderate degree of lung fibrosis was observed in 92% of the rats in the high concentration (16mg/m3) exposure group, and a minimal to mild degree of fibrosis was noted in 22% of the animals in the middle (4mg/m3) exposure group, but no pulmonary change was reported in the lowest (1mg/m3) exposure group, the most relevant level to potential human exposures.

Signs and Symptoms of Exposure: Minimal irritation to respiratory tract may occur as with exposure to any

 

non-toxic dust.

Medical Conditions Generally Aggravated by Exposure: None

Emergency and First Aid Procedures:

Inhalation;

Remove to fresh air. If effects occur, consult medical personnel.

Eye;

In case of contact, immediately flush eyes with water for 15 minutes.

65

Image 67
Contents AL-1670 For Your Protection Contents Safety Precautions Main Features Part Names and Functions Part Names and Functions Paper Size indicators Operation panel and keys for printer featuresAUTO/MANUAL/PHOTO / / key and indicators p Original Size Enter key and indicators p@3AUTO Image key and indicator p Key and indicators@1ORIGINAL Data indicator @2Light and dark keys and indicatorsDo not install your copier in areas that are Copier InstallationGetting Started Unpacking Checking Packed Components and AccessoriesSET-UP Install the TD cartridgeGently lift and pull out the paper tray until it stops Store the pressure plate lock which has been removed Turn the power switch on Load copy paperSET-UP Front of the paper trayPush the paper tray firmly back into the copier Loading Copy PaperLoading Copy Paper Press the Start key and then the Paper Size 11ENTER key Turn the power switch on Using the SPFNormal Copying Press the Start key Set the number of copies using the two copy quantity KeysStream feeding mode Normal CopyingAdjust the copy density Using the original tableNormal Copying Enter the number of copies Press the Start key REDUCTION/ENLARGEMENT/ZOOMAutomatic Press the Auto Image KeyManual REDUCTION/ENLARGEMENT/ZOOMUnfold the bypass tray Bypass Feed special paperBypass Feed special paper TWO-SIDED Copying Offset stack Sort modeGroup mode SORT/GROUPSORT/GROUP Copying in the sort modeSet the originals face up in the document feeder tray Interrupting a Copy RUN When all Interrupt copies are finished, pressPress the Interrupt key Automatic Exposure Adjustment To enter the toner save mode, press the light key Toner Save ModePress the copy ratio display Key XY ZoomSet the number of copies and press the Start key XY ZoomReverse Press the Dual page Copy key Dual page CopyRotation Copying 1 or 4 Press the 2 in 1 / 4 in 1 key to complete the selection Select the desired pattern number using copy quantity keysKey to select the paper tray Press the Erase key to select the desired erase modeErase Use the Tray SelectMargin Shift Genuine Supplies TD Cartridge ReplacementTD Cartridge Replacement Drum Cartridge Replacement Drum Cartridge Replacement Open the feeding roller cover and pull the original gently Misfeed RemovalMisfeed in the SPF First confirm the misfeed locationIf the misfed original cannot be removed in steps 1 Misfeed RemovalMisfeed in the bypass tray Misfeed in the copierRemoving it Fusing unit is hot. Take care in removing paperPush gently the right side of the front cover to open Cover Misfeed in the transport area Grasp the handle of the lower side cover and gently open Misfeed in the upper paper trayMisfeed in the lower paper tray Close the side cover by pressing the handle on the coverClose the paper tray Close the lower side cover Remove the misfed paperPress and hold the light key for more than Setting the user programsUser Programs List of user programsUser Programs Enter a program number using the left copy quantity KeyEntered value will be stored Preheat mode Power Save ModesAuto power shut-off mode Copying from the auto power shut-off mode Power Save ModesSetting the power save modes Copying from the preheat modeTransfer charger User MaintenanceOriginal table and document feeder cover Bypass tray paper feed rollerCharger cleaner out by holding the tab User MaintenanceGently lift and pull out the upper paper tray and take Copier TROUBLE? Problem SolutionCopier TROUBLE? Self-diagnostic functionExample Supply list SuppliesTypes and sizes of copy paper Supply part numbersStore the supplies in a location that is SuppliesGenuine supplies statement Proper storageMoving Instructions Turn the power switch off and disconnect the power CordPush the paper tray back into the copier Copier SpecificationsSingle Pass Feeder SpecificationsIndex Index Material Safety Data Sheet Flammable Limits Ignition TemperatureSpecial Fire Fighting Procedure Flash Point Method UsedOther Limits Ingredients CAS No ProportionHealth Hazards None required under normal use Page Sharp Corporation