Connection with RS-232 cable, Set the ID No

■ Connection with RS-232 cable

If you connect the monitor in a daisy chain using RS-232 cable, using the monitor buttons on the master (main unit), settings are copied to the slave (expansion unit) and operation from the master can perform operation for all monitors. Setting each ID No. in the monitor is required.

1.Connect the monitors in order.

The first monitor will be set as master (main unit) and the second monitor and beyond will be slaves (expansion units).

Connect the RS-232C output terminal of the first monitor (master) and the RS-232C input terminal of the second monitor (slave) together using RS-232 cable (straight). Connect in the same way to the third and subsequent monitors.

Up to 25 monitors can be connected. (Depending on the length of the cable used and the surrounding environment.)

First monitor: master Second monitor: slave

RS-232C	RS-232C	RS-232C
output terminal	input terminal	output terminal

RS-232 straight cable (commercially available)

Third monitor: connects to slave RS-232C input terminal

2. Set the ID No.

Perform operation with the monitor buttons on the master. If you set AUTO ASSIGN ID No., located in the main menu of the monitor to ON, the ID No. will be automatically assigned in order from the master. (See Operation Guide.) (If you attach the control kit (optional), you can perform operation of the monitors with the remote control unit.)

■ Connection with the control kit (optional)

If performing operation of the monitor with the remote control unit, the PN-ZR01 control kit (optional) is required.

•Can perform operation of an arbitrary monitor or all monitors with the remote control unit of the first monitor.

•Can perform operation of up to 25 monitors.

•Connect the monitors together in a daisy chain with RS-232 cable.

Connecting Peripheral Equipment

Attach the remote control sensor box to one of the areas listed below.

*When attached to the left side, because the top and bottom for the remote control sensor box will be reversed (the connection cable will be on top), the right side is recommended.

For the monitor in	For the monitor in
horizontal orientation	vertical orientation

1.Insert the anti-rotation protrusion of the fixing arm into the anti-rotation hole of the monitor.

2.Secure the stand angling hole of the monitor with the mounting screw.

3.Adjust the angle of the remote control sensor box, and secure it with the fixing screw, so that it may accurately receive signals from the remote control unit.

Stand angling hole

Remote control sensor box

	Angle
	adjustment
	Fixing screw	Anti-rotation hole
	Fixing screw	Anti-rotation protrusion
	Mounting screw	Anti-rotation protrusion
	Mounting screw	Fixing arm
		Fixing arm

4.Insert the remote control sensor box connection cable into the control kit terminal.

Remote control sensor box

Control kit terminal

Connection cable

*Do not connect the cable after extending it with a commercially available cable.

TIPS

•When you connect the remote control sensor box, the brightness sensor can be used.

The screen brightness will automatically change according to lighting conditions and the surrounding brightness. (See Operation Guide.)

Brightness sensor

ENGLISH

9 E