www.vxitech.com
INHOUSE:CLEAR_LATCH
The INHOUSE:CLEAR_LATCH command determines whether the first latched information will be cleared when the information is read by word serial FETch:LATChed? Command or if pseudo is set and a register read of the first latched information occurs. The information will not be cleared if a hardware register read is used. When the first latched information is cleared, all the following reads will return a value of 0 until a new first latched event occurs. It is important to note that all letters in the command must be provided as there is no short form for this command.
INHOUSE:CLEAR_LATCH <boolean> | Where <boolean> is 0 OFF 1 ON. |
|
|
EXAMPLES |
|
INHOUSE:CLEAR_LATCH 1 | Clears the first latched information on a |
| read. |
INHOUSE:CLEAR_LATCH? | Returns 1 stating that the first latched |
1 | information will be cleared on a read. |
FETC:LATC? | Reading the first latched information. This |
1 | also clears the latched information. |
FETC:LATC? | Reading the first latched information |
0 | returns a value of 0 once the clearing of |
| latch information was enabled (assuming |
| no further latching occurred). |
VM4016 Programming | 25 |