MRV Communications TS700/G, TS700/155, TS800/155, TS700/100 user manual Mrv

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

E. TS700/G - Gigabit-Ethernet System

The TereScope 700/G supports Gigabit Ethernet and FiberChannel protocols. The physical design and configuration of the TS700/G is similar to the other members of the series, and its operational principles are essentially the same. However, The TS700/G only offers a duplex fiber interface. The standard is 850nm SC multimode. (850nm ST multimode, 1310nm and 1550nm SC singlemode are available on request).

	AIR RX	F/O RX			USE COPPER CONDUCTORS ONLY
	FLAG	FLAG
MANAGEMENT	LASER				LOW	+/~	G	-/~
	ENABLED				VOLT.
	OPTICAL POWER		AIR	LASER	VOLT.HIGH	L	G	N
			FLAG	F/OENABLED		TORQUE VALUE 7 Lb-Inch
		POWER		FLAG

POWER

	Transmitter	Not	Ip	Data
	Mode	Used	Address	Rate
Switch	1	2	3	4
Position
UP	Normal		Software	Gigabit
			IP	Ethernet
			Default	Fiber
DOWN	Attenuated			Channel
			IP
				1.0625

DRY-CONTACT

FIBER OPTIC

TELESCOPE

TX RX

MRV

1762318-SC

Figure 1.7: TS700/G Model Back Panel

Table 5: TS700/155 Standard Model Back Panel Controls, Interfaces, and Indicators

Connectors	Power	Power source Terminal Block (Main or UPS)
		AC power supply (100 to 240 Vac) or DC power
		supply (24 to 60 Vdc)
	Fiber optic	Fiber Optic interface for connection to the
		peripheral equipment.
		The standard interface is MM 850nm SC connector;
		other interfaces are available upon request.
	Management	Connection to 10base-T SNMP management
	(Standard)	interface.
	Dry Contact	There are 4 pairs of dry contact indicators available:
		#	Power
		# Air RX Link LED
		#	F/O Flag LED
		#	Laser Enabled
		Dry contacts are normally closed (25 ohms), and
		open in an alarm condition

13