MRV Communications TS700/155, TS800/155, TS700/100 Attachment of the Transceiver TereScope Head

Page 48

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

Note

The Tower Mount and the Clamping Plate are not provided with the equipment and should be supplied by the installer.

3- Attachment of the Transceiver (TereScope Head)

After securely attaching JMP-L to the mounting surface choose one of the three possible directions for installation of the Alignment Kit (Standard A, B or C) depending on the location of the transceiver at the opposite side. Mount the aiming anchor (I) in accordance with the chosen direction.

Bolt for the attachment of the Alignment Bracket to the JMP

Figure 5.17: Alignment kit mountedon JMP-L – Back view

Mount the Transceiver attached to the mounting bracket front face oriented towards the opposite site using the provided screws (F1, G1). Tighten firmly these screws.

38

Image 48

Contents UserManual UserManual TableofContents P E N D I Standards Standards ComplianceFCC Notice CE MarkMRV  Laser Safety Certification Other StandardsDisclaimer TrademarksAboutthisUserManual SafetyRequirements Before InstallingServicing Carefully Read the Entire Manual Before Installing IntroductionUsing the Part Number for Ordering TheProductModels Part Number Description Front MRV Back Panel Description TS800/155 Standard Model DS1 Toggles Data Rate DIP switch TS800/155-F Standard Model including Fusion option Fusion Operation Mode RF TransceiverFusion 5b TS & FusionTS700/100 Fast-Ethernet System OFF Auto-negotiation, on Forced MRV Display LEDs,Dry Monitoring and Management options ManagementDry contact Only TS800 Typical Connection Fiber ConnectionCopper Connection SiteSurvey Line of SightOrientation Location & RangeConsult Factory in Case of Doubt Optimal Mounting Mounting Environment & Stability Unacceptable MountingPage Wall Mounting using JMP and JMB Transmitting through a Window12 shows the arrangement for transmitting through a window Power Data/Signal CablingInfrastructure Handle the Fibers Very Carefully Setup BenchTestCompatibility Test equipmentTS700/100Fastethernet Bench test IR linkIndicators Display and ResultsReceived power Expected ResultsInstallation AccessoriesDescription Part Description TereScope Parts External viewAiming Head Adjustment and Locks Installer Tool Kit JITK-L MountingDetachment of the TS from the JMP-L Mounting the accessories Standard position aSpecial Mounting Mounting on the floorMounting on a fragile/crumbly wall JMP-LAttachment of the Transceiver TereScope Head 17 Alignment kit mountedon JMP-L Back viewAimingProcedure Powering on the TereScopeProcedure Transceiver AlignmentGeneral Tools and EquipmentFine Alignment 13 Position after the horizontal aiming 15a and 6.15b Alignment screws InstallationCompletion Link Operating TestBefore Closing the Rear Door Visual Inspection17 Mounted TereScope Left View Maintenance Accuracy should be examined and restored if necessaryPeriodic Visits Appendix a TS700/100 Fast-Ethernet Light TS800/155 high speed Light TS700/G Giga-Light Appendixb Appendixc Packing box containsAppendixd Where to use List of the Tools Supplied by MRV CommunicationsIntroduction Points to RememberInterference Figure E.3 Active Transmitters Shown Darkened Page Appendixf Effect of Wind on Terescopes AppendixG FSO ChainingUse the indoor switch in building C for the chaining Indirect ChainingFSO products & Chaining Product series No of chained links Appendixh Site survey Installation System failure Appendixi