MRV Communications TS800/155, TS700/155 Monitoring and Management options, Dry contact Only TS800

Page 25

M R V C o m m u n i c a t i o n s , I n c . – I n s t a l l a t i o n M a n u a l

Monitoring and Management options

1 – Management

The TS is manageable by using SNMP option. SNMP monitoring can be performed via MegaVision, MRV’s SNMP software.

RJ45

Connection for

SMNP

Interface

Figure 1.8: SNMP + TS

2 - Dry contact (Only TS800)

The TS can be connected to dry contact box (RSM-DC). The RSM-DC is directly attached to TS at "Remote Monitor" connector.

RSM-DC

Figure 1.9: RSM-DC + TS

3 – RSM (Only TS800)

RSM connection

RSM

The TS can be connected to monitoring unit: RSM. The connection between the TS and the RSM is made with 7 wires twisted cable.

Figure 1.10: RSM + TS

15

Image 25
Contents UserManual UserManual TableofContents P E N D I Standards Compliance StandardsFCC Notice CE MarkOther Standards MRV  Laser Safety CertificationDisclaimer TrademarksAboutthisUserManual Before Installing SafetyRequirementsServicing Introduction Carefully Read the Entire Manual Before InstallingTheProduct Using the Part Number for OrderingModels Part Number Description Front MRV Back Panel Description TS800/155 Standard Model DS1 Toggles Data Rate DIP switch TS800/155-F Standard Model including Fusion option RF Transceiver Fusion Operation Mode5b TS & Fusion FusionTS700/100 Fast-Ethernet System OFF Auto-negotiation, on Forced MRV Display LEDs,Dry Management Monitoring and Management optionsDry contact Only TS800 Fiber Connection Typical ConnectionCopper Connection Line of Sight SiteSurveyOrientation Location & RangeConsult Factory in Case of Doubt Optimal Mounting Unacceptable Mounting Mounting Environment & StabilityPage Transmitting through a Window Wall Mounting using JMP and JMB12 shows the arrangement for transmitting through a window Data/Signal Cabling PowerInfrastructure Handle the Fibers Very Carefully BenchTest SetupCompatibility Test equipmentTS700/100Fastethernet IR link Bench testDisplay and Results IndicatorsExpected Results Received powerAccessories InstallationDescription TereScope Parts External view Part DescriptionAiming Head Adjustment and Locks Mounting Installer Tool Kit JITK-LDetachment of the TS from the JMP-L Standard position a Mounting the accessoriesMounting on the floor Special MountingJMP-L Mounting on a fragile/crumbly wall17 Alignment kit mountedon JMP-L Back view Attachment of the Transceiver TereScope HeadPowering on the TereScope AimingProcedureTransceiver Alignment ProcedureGeneral Tools and EquipmentFine Alignment 13 Position after the horizontal aiming 15a and 6.15b Alignment screws Link Operating Test InstallationCompletionBefore Closing the Rear Door Visual Inspection17 Mounted TereScope Left View Accuracy should be examined and restored if necessary MaintenancePeriodic Visits Appendix a TS700/100 Fast-Ethernet Light TS800/155 high speed Light TS700/G Giga-Light Appendixb Packing box contains AppendixcAppendixd List of the Tools Supplied by MRV Communications Where to usePoints to Remember IntroductionInterference Figure E.3 Active Transmitters Shown Darkened Page Appendixf Effect of Wind on Terescopes FSO Chaining AppendixGIndirect Chaining Use the indoor switch in building C for the chainingFSO products & Chaining Product series No of chained links Appendixh Site survey Installation System failure Appendixi