Murphy CE-05171N manual Port Response Delay Port 1 Baud Rate

6.3.12 Initial RPM Setup

C	TM
INITIAL RPM SETUP
WARMUP RPM	▼
WAIT FOR LOAD RPM
RUN LOADED RPM
COOLDOWN RPM

___________________________________

00600 ▼

___________________________________

▼▲	ENTER-EDIT
▼ ▼	MORE MENUS

Initial RPM Setup Screen

a)Assign value for Warmup RPM.

b)Assign value for Wait to Load RPM.

c)Assign value for Run Loaded RPM.

d)Assign value for Cooldown RPM.

6.3.13 Miscellaneous Setup

	C	TM
MISCELLANEOUS SETUP
NUMBER OF CRANK ATTEMPTS		▼
PORT 1	SLAVE ADDRESS
PORT 1	RS432/RS485
PORT 1	RESPONSE DELAY

PORT 1 BAUD RATE

___________________________________

	00003	▼
___________________________________
▼▲	ENTER-EDIT
▼ ▼	MORE MENUS

Miscellaneous Setup Screen

User can access and edit the miscellaneous settings.

a)Crank Attempts: Define a value for number of crank attempts after which an over-crank sequence will be trig- gered in the Event logic.

b)Controller Slave Address: Provide the value for the Modbus Address Port. The factory default is 1.

c)Port 1 Mode: Select Communication Port 1 as RS232, or RS485.

d)Port 1 Reply Delay: To ensure sufficient time for the Modbus reply, assign appropriate time value for Delay Modbus Reply Port 1.

e)Port 1 Baud Rate: Select appropriate transmission baud rate

f)Port 2 Mode: Select Communication Port 2 as RS232, or RS485.

g)Port 2 Reply Delay: To ensure sufficient time for the Modbus reply, assign appropriate time value for Delay Modbus Reply Port 2.

h)Port 2 Baud Rate: Select appropriate transmission baud rate

i)Flywheel Teeth: Define a value for Flywheel Teeth used to calculate RPM.

The following cold temperature offset values should only be adjusted by personnel with a full working knowledge of the Centurion in conjunction with calibrated reference equipment.

j)Core Cold Temp Offset: Enter a non-zero Value for Core Temperature Adjustment (in tenths) to adjust the temperature readings for all Thermocouple inputs on both the Main I/O Module (C3-1). Entering a non-zero value will adjust the Cold Junction Compensation reading used to calculate temperature.

k)Exp Cold Temp Offset: Enter a non-zero Value for Expansion Board Temperature Adjustment (in tenths) to adjust the temperature readings for all Thermocouple inputs on Expansion I/O (C3-2). Entering a non-zero value will adjust the Cold Junction Compensation reading used to cal- culate temperature.

l)Hour Meter: The user may make hour meter adjustments. The range is 0 – 65535 hours.

CE-05171N page 31 of 44