Multi-Tech Systems MT5634MSV Vn Protocol Result Code, Xn XON/XOFF Pass-Through, Data Calling Tone

MessageSaver User Guide

Command:	\Vn	Protocol Result Code
Values:		n = 0, 1, or 2
Default:		1
Description:	\V0	Disable the appending of the protocol result code to the DCE
		speed.
	\V1	Enable the appending of the protocol result code to the DCE
		speed.
	\V2	Same as \V1.
Command:	\Xn	XON/XOFF Pass-Through
Values:		n = 0 or 1
Defaults:		0
Description:	\X0	Modem responds to and discards XON/XOFF characters.
	\X1	Modem responds to and passes XON/XOFF characters.
Command:	-Cn	Data Calling Tone
Values:		n = 0 or 1
Defaults:		0
Description:	-C0 Disable V.25 data calling tone to deny remote data/fax/voice
		discrimination.
	-C1 Enable V.25 data calling tone to allow remote data/fax/voice
		discrimination.
Command:	%B	View Numbers in Blacklist
Values:		n/a
Description:		If blacklisting is in effect, AT%B displays the numbers for
		which the last call attempted in the previous two hours failed.
		In countries that do not require blacklisting, the ERROR result
		code appears.
Command:	%Cn	Data Compression Control
Values:		n = 0 or 1
Default:		1
Description:	%C0	Disable V.42bis/MNP 5 data compression.
	%C1	Enable V.42bis/MNP 5 data compression.
Command:	%DCn	AT Command Control
Values:		n = 0 or 1
Default:		0
Description:	%DC0 The modem responds to AT commands.
	%DC1 The modem ignores AT commands.

Note: The modem will respond to AT%DC for 10 seconds after power-up.

Command:	%En	Fallback and Fall Forward Control
Values:		n = 0, 1, or 2
Default:		2
Description:	%E0	Disable fallback and fall forward.
	%E1	Enable fallback, disable fall forward.
	%E2	Enable fallback and fall forward.

40