Datacom Systems VS-1200 manual Serial Port Configuration DB9, Delete User Username, HyperTerminal

Page 26

26

VS-1200 Data Acccess Switch

4.1.4.15 DELETE USER (DE US)

This command deletes users as shown:

DELETE USER (USERNAME)

Example: # DE US edituser

User edituser deleted

#

4.2SERIAL Port Configuration (DB9)

Note: Use of the SERIAL DB9 port, which is fairly simple and straight forward, is strongly recommended for initial configuration of the hardware.

Once VS-1200 series connection is made to the SERIAL DB9 port, open the terminal emulation application and create a connection with settings that fit your needs:

4.2.1HyperTerminal

The following example utilizes Microsoft HyperTerminal. Any freely available terminal emulator may be utilized, but please take note of the specific HyperTerminal setup settings if an alternate terminal emulator is used.

HyperTerminal (terminal emulator) enter:

9600 bits per second

8 data bits Parity none 1 stop bit

Flow control none

After completing review of the Command Line Interface (CLI) 17 section and Exercise - CLI setting Ports 36 section, detailed IP Address configuration can be found in the IP Address Configuration 28 section.

© 2009 Datacom Systems Inc

Image 26

Contents USERguide Page Product Description VS-1200 Data Acccess Switch Datacom Systems IncTable of Contents VS-1200 Series Functional Drawing Application Hardware InstallationCustomer Service Proprietary Notice Terms of UseCopyright License Agreement Trademark Attribution Certifications and MarksSafety Notices and Warnings Overview VS-1200 Series SummaryVS-1200 Series Features and Benefits What Shipped?Power Consumption 12W BTU/h VS-1200 Series Common SpecificationsVS-1200 Series Model Specific Specifications Operating Range Relative Humidity 5 to 90% non-condensingPage VS-1210BT/SFP HardwareVS-1200 Series Front Panels Any-to-Any Ports PowerFront Panel Description Rear Panel Description Management PortSerial DB9 Power Switch SFP seriesInput Power Rear Label BT seriesBasic Functionality Initial ConfigurationCommand Line Interface CLI Password Recovery Basic Commands Read Only AccessSET Port Monitor SE PO MO Show Groups SH GR Group Name TAPShow Port Routing SH PO RO Show Users SH US Superuser Commands Configuration AccessSU SET Password SU SE PA # SET IP Subnet Gateway SET Date MmddyySET Time Hhmmss # SE PO MO 3 OFFADD User AD US HyperTerminal Serial Port Configuration DB9Delete User Username Port Number Management Port Configuration RJ45TCP/IP Winsock Telnet IP Address ConfigurationIP Address Configuration with HyperTerminal Accessories Communications HyperTerminal VS-1200 Data Acccess Switch Initial Configuration IP Address Configuration with Telnet Network Connections Accessories Command Prompt Initial Configuration Exercise CLI Setting Ports Initial Configuration # SET Port Monitor 1 from 7,9 # SET Port Monitor 2 from 8,9# SET Port Monitor 7 from # SET Port Monitor 5 from# SET Port Monitor 6 from 3,4 # SET Port Monitor 8 fromIntallation Prerequisites Safety GuidelinesSmall Form-Factor Plug Module Installing the SFP Module Removing the SFP ModulePage Any-to-Any Connection Hardware InstallationPower Management Connection VS-1200 Series Functional Drawing VS-1210BT-BT/SFPVS-1204BT VS-1204SFP Gathering the Data HyperTerminal configuration example ApplicationVS-1200 Data Acccess Switch # SET Port Monitor 9 from # SET Port Monitor 4 from# SET Port Monitor 6 from VS-1200 Data Acccess Switch Application # SET Port Monitor 7 from 2,4 # SET Port Monitor 5 from 1,3# SET Port Monitor 6 from 1,3 # SET Port Monitor 8 from 2,4Limits of Liability Customer ServiceInternet Warranty Datacom Systems Inc