Datacom Systems VS-1200 manual Exercise CLI Setting Ports

Page 36

36

VS-1200 Data Acccess Switch

Step 13. If the pending IP Address is not correct, repeat Step 9, if the pending IP Subnet is not correct, repeat Step 10 and if the pending IP Default Gateway is not correct, repeat Step 11. Repeat Step 12 to review and verify that the pending IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default Gateway.

Step 14. Type Exit and press the Enter key to save the network address changes which ends the connection session as indicated in a few seconds by .the Windows informational message balloon pop-up icon "Local Area Connection - A network cable is unplugged."

Step 15. Close TELNET

Step 16. Disconnect the DRL512-2M-R serial cable.

Step 17. Install the VS-1200 series in your chosen network location.

4.5Exercise - CLI Setting Ports

PREMISE: The configurable VERSAstream allows multiple network devices/tools to receive the combined data of multiple Ethernet network segments. All VERSAstream 1200 Series’ Any-to- Any ports can be set to be inputs or outputs as shown in the 'Command Line Interface (CLI) 17 ' section.

© 2009 Datacom Systems Inc

Image 36

Contents USERguide Page Product Description VS-1200 Data Acccess Switch Datacom Systems IncTable of Contents Hardware Installation Customer ServiceVS-1200 Series Functional Drawing Application Terms of Use Copyright License Agreement Trademark AttributionProprietary Notice Certifications and MarksSafety Notices and Warnings Overview VS-1200 Series SummaryVS-1200 Series Features and Benefits What Shipped?VS-1200 Series Common Specifications VS-1200 Series Model Specific SpecificationsPower Consumption 12W BTU/h Operating Range Relative Humidity 5 to 90% non-condensingPage Hardware VS-1200 Series Front PanelsVS-1210BT/SFP Power Front Panel DescriptionAny-to-Any Ports Rear Panel Description Management PortPower Switch SFP series Input PowerSerial DB9 Rear Label BT seriesInitial Configuration Command Line Interface CLIBasic Functionality Password Recovery Basic Commands Read Only AccessSET Port Monitor SE PO MO Show Groups SH GR Group Name TAPShow Port Routing SH PO RO Superuser Commands Configuration Access SU SET Password SU SE PAShow Users SH US # SET IP Subnet Gateway SET Date MmddyySET Time Hhmmss # SE PO MO 3 OFFADD User AD US Serial Port Configuration DB9 Delete User UsernameHyperTerminal Management Port Configuration RJ45 TCP/IP WinsockPort Number IP Address Configuration IP Address Configuration with HyperTerminalTelnet Accessories Communications HyperTerminal VS-1200 Data Acccess Switch Initial Configuration IP Address Configuration with Telnet Network Connections Accessories Command Prompt Initial Configuration Exercise CLI Setting Ports Initial Configuration # SET Port Monitor 1 from 7,9 # SET Port Monitor 2 from 8,9# SET Port Monitor 5 from # SET Port Monitor 6 from 3,4# SET Port Monitor 7 from # SET Port Monitor 8 fromSafety Guidelines Small Form-Factor Plug ModuleIntallation Prerequisites Installing the SFP Module Removing the SFP ModulePage Hardware Installation PowerAny-to-Any Connection Management Connection VS-1200 Series Functional Drawing VS-1210BT-BT/SFPVS-1204BT VS-1204SFP Gathering the Data HyperTerminal configuration example ApplicationVS-1200 Data Acccess Switch # SET Port Monitor 4 from # SET Port Monitor 6 from# SET Port Monitor 9 from VS-1200 Data Acccess Switch Application # SET Port Monitor 5 from 1,3 # SET Port Monitor 6 from 1,3# SET Port Monitor 7 from 2,4 # SET Port Monitor 8 from 2,4Customer Service Internet WarrantyLimits of Liability Datacom Systems Inc