Datacom Systems VS-1200 manual Initial Configuration

Page 31

Initial Configuration

31

Step 8. SET IP (SE IP) by typing se ip xxx.xxx.xxx.xxx corresponding to a valid IP address for your network. Press the Enter key to continue.

Step 9. SET SUBNET (SE SU) by typing se su xxx.xxx.xxx.xxx corresponding to your network's subnet mask. Press the Enter key to continue.

Step 10. SET GATEWAY (SE GA) (if needed) by typing se ga xxx.xxx.xxx.xxx corresponding to your network's default gateway. Press the Enter key to continue.

Step 11. SHOW (SH) by typing sh and press the Enter key to display and affirm that the pending IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default Gateway.

Step 12. If the pending IP Address is not correct, repeat Step 8, if the pending IP Subnet is not correct, repeat Step 9 and if the pending IP Default Gateway is not correct, repeat Step 10. Repeat Step 11 to review and verify that the pending IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default Gateway.

© 2009 Datacom Systems Inc

Image 31

Contents USERguide Page Product Description Datacom Systems Inc VS-1200 Data Acccess SwitchTable of Contents Customer Service Hardware InstallationVS-1200 Series Functional Drawing Application Certifications and Marks Terms of UseCopyright License Agreement Trademark Attribution Proprietary NoticeSafety Notices and Warnings VS-1200 Series Summary OverviewWhat Shipped? VS-1200 Series Features and BenefitsOperating Range Relative Humidity 5 to 90% non-condensing VS-1200 Series Common SpecificationsVS-1200 Series Model Specific Specifications Power Consumption 12W BTU/hPage VS-1200 Series Front Panels HardwareVS-1210BT/SFP Front Panel Description PowerAny-to-Any Ports Management Port Rear Panel DescriptionRear Label BT series Power Switch SFP seriesInput Power Serial DB9Command Line Interface CLI Initial ConfigurationBasic Functionality Basic Commands Read Only Access Password RecoverySET Port Monitor SE PO MO TAP Show Groups SH GR Group NameShow Port Routing SH PO RO SU SET Password SU SE PA Superuser Commands Configuration AccessShow Users SH US SET Date Mmddyy # SET IP Subnet Gateway# SE PO MO 3 OFF SET Time HhmmssADD User AD US Delete User Username Serial Port Configuration DB9HyperTerminal TCP/IP Winsock Management Port Configuration RJ45Port Number IP Address Configuration with HyperTerminal IP Address ConfigurationTelnet Accessories Communications HyperTerminal VS-1200 Data Acccess Switch Initial Configuration IP Address Configuration with Telnet Network Connections Accessories Command Prompt Initial Configuration Exercise CLI Setting Ports Initial Configuration # SET Port Monitor 2 from 8,9 # SET Port Monitor 1 from 7,9# SET Port Monitor 8 from # SET Port Monitor 5 from# SET Port Monitor 6 from 3,4 # SET Port Monitor 7 fromSmall Form-Factor Plug Module Safety GuidelinesIntallation Prerequisites Removing the SFP Module Installing the SFP ModulePage Power Hardware InstallationAny-to-Any Connection Management Connection VS-1210BT-BT/SFP VS-1200 Series Functional DrawingVS-1204BT VS-1204SFP Application Gathering the Data HyperTerminal configuration exampleVS-1200 Data Acccess Switch # SET Port Monitor 6 from # SET Port Monitor 4 from# SET Port Monitor 9 from VS-1200 Data Acccess Switch Application # SET Port Monitor 8 from 2,4 # SET Port Monitor 5 from 1,3# SET Port Monitor 6 from 1,3 # SET Port Monitor 7 from 2,4Internet Warranty Customer ServiceLimits of Liability Datacom Systems Inc