Installing the Avaya G350 Media Gateway
Step 2: Install the media modules
Inserting the S8300 Media Server module
CAUTION:
Hold media modules only by the edges to avoid damage from static electricity. Do not touch the top or bottom of the circuit board. If possible, wear a
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned and then forced into position.
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the spring- loaded captive screws. Use a screw driver to ensure the captive screws are securely tightened to prevent damage to the equipment.
The S8300 can only be inserted in slot V1 on the left side of the G350 Media Gateway.
To insert the S8300 Media Server module
1Remove the plate between slots V1 and V2, labelled “Remove before removing or inserting S8300 module.”
2Remove the blank plate from slot V1.
3Position the media module squarely before the V1 bay opening and engage both sides of the module in the interior guides.
4Slide the S8300 module slowly into the chassis, maintaining an even pressure to assure that the module does not become twisted or disengaged from the guides.
Figure 5: Inserting the S8300 media server module.
Installation of the G350 Media Gateway | 25 |
December 2003 |
|