Connecting devices
Step 1: Connect the network
4 Connecting devices
This chapter describes how to connect all external endpoint devices to the G350. Devices can be connected to the ports on the front panels of the installed media modules and to the fixed front panel ports.
Before you connect endpoint devices, the G350 should be mounted, all media modules should be inserted.
Perform the following steps in order, skipping any devices that you are not installing:
•Step 1: Connect the network
•Step 2: Connect IP telephones
•Step 3: Connect
•Step 4: Install circuit protection
•Step 5: Connect to the Wide Area Network (WAN)
•Step 6: Install the Coupled Bonding Conductor
•Step 7: Install the Avaya Partner Contact Closure Adjunct
The steps are described in the sections below.
As you connect devices, keep a record of the slots and ports into which specific devices are connected. You will need to provide this information to the technician who configures the G350. If your planning documentation specifies which devices should be connected to which ports, follow those instructions.
! WARNING:
To reduce the risk of fire, use only 26 AWG or larger telecommunication line cords when installing telephones or adjuncts.
! WARNING:
Attention: Pour réduire les risques d’incendie, utiliser uniquement des conductors de télécommmunications 26 AWG ou de section supérieure.
Step 1: Connect the network
The G350 can provide network switching and also supports the connection of switches. Therefore, depending on the number of devices on your network, you may need to connect any of the following devices:
•One or more LAN switches.
•The network data ports in the office.
Installation of the G350 Media Gateway | 43 |
December 2003 |
|