Installing the Avaya G350 Media Gateway
Step 2: Install the media modules
5Apply firm pressure to engage the connectors.
The connector has different length pins. The long pins will engage first to provide grounding. Medium length and short pins will provide power and signal.
6Lock the S8300 Media Server module into the chassis by tightening the
7Replace the plate labelled “Remove before removing or inserting S8300 module” between slots V1 and V2, and tighten the screws on the front of the plate.
!DANGER:
To prevent access to electrical hazards by unauthorized personnel and to ensure continued compliance to radiated emissions requirements, all captive screws must be securely tightened such that they cannot be loosened without the use of a tool.
Inserting media modules
After you have inserted the S8300 Media Server module, if applicable, insert the rest of the media modules. Make sure to insert each module in a permissible slot. For information about which slots to allocate to which modules, see Allocating slots on page 23.
CAUTION:
Hold media modules only by the edges to avoid damage from static electricity. Do not touch the top or bottom of the circuit board. If possible, wear a
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if misaligned and then forced into position.
CAUTION:
Separate ESD paths to the chassis ground connect to the media modules at the spring- loaded captive screws. Use a screw driver to ensure the captive screws are securely tightened to prevent damage to the equipment.
To insert a media module:
1Remove the blank plate from the empty bay.
2Position the media module squarely before the selected bay on the front of the G350 chassis and engage both sides of the module in the interior guides.
3Slide the module slowly into the chassis, maintaining an even pressure to assure that the module does not become twisted or disengaged from the guides.
26 | Installation of the G350 Media Gateway |
| December 2003 |