Installing the Avaya G350 Media Gateway
Step 1: Mount the G350 chassis
At this point, you have mounted the G350 chassis in the rack and are ready to insert media modules as required in the planning documentation.
Mounting the G350 on a wall
To mount the G350 on a wall, use the two mounting brackets without cable guides. If the wall is flat, you can screw the G350 directly to the wall. If the wall is not flat, screw a plywood board (415 x 465 mm, 20 mm thick) to the wall with wood screws, and fasten the G350 to the board.
To affix brackets to the G350 for wall mounting:
1Affix a bracket to each side of the G350, as shown in the figure below.
Placing the G350 on a table
If you will be installing the G350 as a tabletop unit, you need to affix the provided four rubber feet to the underside of the G350.
To affix the feet:
1Remove the four feet from their packaging.
2Turn the G350 upside down.
3Position each foot into one of the mounting sites, near each corner of the chassis.
4Press the plastic rivet into the foot with a stylus until it is firmly seated on the chassis.
22 | Installation of the G350 Media Gateway |
| December 2003 |