Axis Communications A1001 user manual Door Connector, Auxiliary Connector, Power Connector

AXIS A1001 Network Door Controller & AXIS Entry Manager

Technical Specifications

Door Connector

Two 4-pin terminal blocks for door monitoring devices (digital input).

All door input pins can be supervised. If the connection is interrupted, an alarm is triggered. To use supervised inputs, install end of line resistors. Use the connection diagram for supervised inputs. See page 62.

Function	Pin	Notes	Specifications
0 V DC (-)	1, 3		0 V DC
Input	2, 4	For communicating with door monitor.	0 to max 40 V DC
		Digital input — Connect to pin 1 or 3 respectively to
		activate, or leave floating (unconnected) to deactivate.
		Note: This pin can only be used for input.

Auxiliary Connector

4-pin configurable I/O terminal block for:

• Auxiliary power (DC output)

• Digital Input

•Digital Output

•0 V DC (-)

For an example connection diagram, see Connection Diagrams on page 61.

Function	Pin	Notes	Specifications
0 V DC (-)	1		0 V DC
DC output	2	For powering auxiliary equipment.	3.3 V DC
		Note: This pin can only be used as power out.	Max load = 100 mA
Configurable	3–4	Digital input — Connect to pin 1 to activate, or leave	0 to max 40 V DC
(Input or Output)		floating (unconnected) to deactivate.
		Digital output — Connect to pin 1 to activate, or leave	0 to max 40 V DC, open drain,
		floating (unconnected) to deactivate. If used with an	100 mA
		inductive load, e.g. a relay, a diode must be connected
		in parallel with the load, for protection against voltage
		transients.

Power Connector

2-pin terminal block for DC power input. Use a Safety Extra Low Voltage (SELV) compliant limited power source (LPS) with either a rated output power limited to ≤100 W or a rated output current limited to ≤5 A.

Function	Pin	Notes	Specifications
0 V DC (-)	1		0 V DC
DC input	2	For powering controller when not using Power over	10–30 V DC, max 26 W
		Ethernet.	Max load on outputs = 14 W
		Note: This pin can only be used as power in.

59