Impulse PCW-5181 Inserting and Removing Mounting Brackets from the Impulse, Installation, Removal

Chapter 3 - Connecting and Installing Your Impulse

Inserting and Removing Mounting Brackets from the Impulse

Both Impulse mounting brackets are interchangeable and each is inserted or removed according to the following procedures. No tools are required to insert a bracket, however a flat-bladed screwdriver is required for removal. If additional brackets are required, see Chapter 2, Shipping Contents, for part numbers.

Installation of Bracket (DIN Rail Bracket Shown)

1.Insert the bracket into the bracket housing from the top side of the Impulse as shown in the drawing on the right.

2.Slide bracket downward until a single click is felt (detent position). The bracket will be seated in the position shown at right. Note: If you push the bracket beyond the detent position (second click), it will be necessary to push the bracket back to the detent position.

Do not attempt to remove the bracket by pulling it from the bottom of the bracket housing. Both bracket and bracket housing could be permanently damaged.

Removal of Bracket (DIN Rail Bracket Shown)

1.Insert the tip of a flat-bladed screwdriver between the bracket-release arms as shown in the drawing at right.

2.Gently twist the tip of the screwdriver until the arms are spread apart enough to clear the detent mechanism on the housing. Maintain this position.

3.While holding the arms apart with the screwdriver, push the bracket toward the top of the bracket housing as shown in the drawing.

Do not attempt to remove the bracket by pulling it from the bottom of the bracket housing. Both bracket and bracket housing could be permanently damaged.

1 Insert

Bracket

Installation

2

Slide Bracket into

Position as

Shown Here

Removal

1

Insert screwdriver blade perpendicular to bracket (profile of blade shown in spread position)

2

Twist until arms are spread apart - hold in position

Push bracket free of

3arms and out the

bracket housing

3-12