Impulse PCW-5181 user manual Configuring Idle Mode Current Reduction Parameters, Stall Detection

Chapter 5 - Configuring Impulse with an IDC Keypad

Configuring Idle Mode Current Reduction Parameters

Use this option to set the Idle Mode current-reduction parameters (TIMEOUT and %RED).

TIMEOUT sets the Idle Mode current reduction period in seconds. When the TIMEOUT period has elapsed, the commanded motor current will be reduced by the percentage defined in EDIT > SETUP

>ADVNCE > I-IDLE > %RED. Full current is restored on the next commanded step. The valid range for the timeout is 0 to 3600 seconds. Setting the timeout to 0 disables the Idle Mode feature and the display will read “Off”.

%RED (percentage of reduction) sets the percentage of current reduction that occurs after the Idle Mode TIMEOUT has expired. The valid range for percentage of reduction is 0 to100%. The Idle Mode reduction percentage takes precedence over the Stop Mode 25% reduction if both modes have been enabled.

EDIT > SETUP > ADVNCE > I-IDLE

TIMEOUT

1.Press TMEOUT (F1).

2.Using the numeric and decimal keys, enter the desired current-reduction period (seconds).

3.Press ESC.

%REDUCTION (required only if TIMEOUT was configured)

1.Press %RED (F2).

2.Using the numeric keys, enter the desired percentage of reduction (no decimal).

3.Press ESC.

- IDLE MODE REDUCT - TMEOUT %RED

- Idle Mode Tmeout -

Off

- Idle Mode %Redct -

0%

Configuring Encoderless Stall-Detection (OLSD™)

This option allows you to enable or disable the OLSD™ feature. OLSD™ becomes active at velocities of 0.5 RPS and greater.

EDIT > SETUP > ADVNCE > STALL

-	Stall Detection	-
↑	DISABLED	↓

1.Using the up and down arrows, toggle to DISABLED or ENABLED OLSD™ .

2.Press ESC twice to return to the EDIT > SETUP menu.

5-19