Datamax E-4204, E-4203, E-4304e manual Control Codes Form Length

9) CONTROL CODES	10) CONT FORM LENGTH
Allows code selection listed in	Sets the page (label) size when the
Programmer’s manual.	‘SENSOR TYPE’ is set to continuous
Possible Values:	media.
	Possible Values:
* (STD) Standard Codes
	Range: 0 – 9999; default = *100
(ALT) Alternate Codes
	(Units = .01 inch)
11) OOS MAXVOLT	12) TOF GAIN
Sets the media sensor level for the	Sets media sensor Top of Form gain
Out Of Stock condition.	value.
Possible Values:	Possible Values:
Range: 0 – 16; default = *2	Range: 0 – 15; default = *10
(Units = .1 volt)
13) TOF DELTA	14) TOF LOW
Sets the minimum media sensor	Sets the minimum media sensor reading
change required to signify a label	for paper (gap/notch) or mark
gap or mark.	(reflective).
Possible Values:	Possible Values:
Range: 0 – 50; default = *10	Range: 0 – 50; default = *0
(Units = .1 volt)	(Units = 0.1 volt)
15) LABEL WIDTH	16) SCALABLE FONT
Sets the label width.	Sets the number of memory blocks to
Possible Values:	allocate for scalable fonts.
	Possible Values:
Range: 75 – 410; default = *410
(Units = .01 inch)	Range: 0 – 128; default = *64
	(Units = 4K Bytes)
17) INTERNAL MODULE	18) LABEL ALIGNMENT
Sets the number of memory blocks to	Sets the label alignment method (see
allocate for the internal RAM	Section 4.5).
module.	Possible Values:
Possible Values:
	YES	(user manually determines
Range: 0 – 128; default[1] = *128
		‘ALIGN LENGTH’)
(Units = 4K Bytes)	AUTO (printer determines ‘ALIGN
[1] The E-4304 has a default value of 64.		LENGTH’)
	* NO	(no Label Alignment used)
24		E-4203/E-4204/E-4304