Datamax E-4204, E-4203, E-4304e manual ~Or~

+

Problem	Possible Cause		Solution
Tear Mode is	Another present	¾	Disable the Present Sensor.
selected but the	position has been		~OR~
label stop position	determined.
(present position) is	Enabling the	¾	Ensure the host computer is
not far enough	Present Sensor		not providing a Present
forward.	causes the label		Distance shorter than is
	stop position		required for the Tear Bar.
	(present position)
	to be approximately
	0.1” behind the
	peel bar.
	~OR~
	The Present Adjust	¾	Use the Setup Menu to modify
	value is not correct.		the Present Adjust value.
Tear Mode is	Another present	¾	Ensure the host computer is
selected but the	position has been		not providing a Present
label stop position	determined.		Distance longer than is
(present position) is			required for the Tear Bar.
too far forward.	~OR~
	The Present Adjust	¾	Use the Setup Menu to modify
			the Present Adjust value.
	value is not correct.
The FAULT	The label supply is	¾	Load media.
Indicator	empty
illuminates during
label alignment.

E-4203/E-4204/E-4304 33