5.6Darkness Adjustment
The Darkness Adjustment (located on the rear of the printer) allows the operator to match the print contrast following a printhead replacement. Turning the Darkness Adjustment clockwise will darken the print, while turning it counterclockwise will lighten the print. Compare a label printed with the old printhead and make this adjustment so that the new printhead matches the darkest portion of that label.
;Note: Large increases in the ‘Darkness Adjustment’ can shorten printhead life. If you need to increase the darkness of the printed labels, increase the Heat value and/or slow the Print Speed using your software program or via DPL commands.
5.7 Resetting to the Factory Defaults
With the printer power ‘Off,’ press and hold the F1, F2, and F3 buttons while turning ‘On’ the printer. Continue to hold the buttons down until the PAUSED Light turns off. The printer will now be set to the ‘Factory Defaults.’ See Section 4.4.1 for a listing of the factory default settings.
5.8Downloading Firmware and Fonts
The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When program updates and/or new features are added, they can be downloaded to the printer as follows:
1.Identify the new version for your model of printer from the Datamax FTP site at ftp://ftp.datamaxcorp.com and download it onto your computer’s hard drive or a floppy disk.
2.Ensure that the printer is connected to the host and that the power is ‘On.’ Using the DOS copy command enter:
copy filename.dlf lpt1/b
;Note: Other programs (e.g.,
| 47 |